Flat RoofingContractors

Commercial and blocks

Commercial flat roofing across Powys

Commercial owners and facilities managers in Powys can use a paid condition report to plan budgets, then phase re-roofing over one or more years with each section priced separately. When you are ready to replace, the survey and fixed written quote are free, and building control is handled where the work needs approval.

Large grey membrane flat roof with plant and edge protection on a retail and warehouse unitComputer-generated example image
Guide price
£12,150–£20,050
Survey
Free for new and replacement roofs
Quote
Fixed, in writing
Coverage
England, Wales, Scotland, NI

Powys at a glance

Largest towns
Newtown, Brecon
Postcode areas
LD, SY
Building control
Powys County Council
Neighbouring areas
Blaenau Gwent · Ceredigion · Merthyr Tydfil · Torfaen
Guide price region
Wales (−8% on West Midlands rates)

How much does a commercial flat roof cost in Powys?

Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Commercial roof (100 m²), single-ply + insulation£12,150–£20,050
Condition survey and leak investigation£140–£280
Block of flats (150 m²), felt + insulation + scaffold£14,300–£25,000

Which flat roofs are common in Powys?

Flat roofs in Powys sit on lock-up garage blocks on estates, 1960s and 1970s link-detached houses with flat-roofed garages and porches and terraced streets with flat-roofed rear kitchens and bathrooms. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in Wales

Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Powys the application goes to Powys County Council. More on the rules.

How do you handle CDM, roof access and fragile surfaces?

Every job is planned under the Construction (Design and Management) Regulations 2015, or CDM (NI) 2016 in Northern Ireland, with a construction phase plan and a method statement for the roof.

As a commercial client you have duties under CDM too, including passing on information about the building, such as drawings, details of previous roof work and the asbestos register. Buildings put up before 2000 can contain asbestos, so we ask for the register or a refurbishment survey before pricing a strip-out. If asbestos is found, a licensed specialist surveys and removes it before we start.

Roofs and rooflights are treated as fragile until a competent person confirms otherwise. Edge protection goes up on every job, rooflights and fragile sheets are covered or fenced off, and we agree safe access before work starts: scaffold, a tower, a powered access platform or a fixed access point where one is suitable.

Which roofing system suits a commercial flat roof?

Single-ply membrane usually suits large, simple roofs; built-up felt suits roofs with heavy foot traffic, plant or complex detailing; and a liquid-applied overlay suits a sound roof that needs new waterproofing without a full strip-out.

  • Single-ply (PVC, TPO or FPO): light and quick to lay over large areas, with hot-air welded laps and fixing or bonding designed for the site's wind uplift. Indicative life 25–35+ years. See single-ply roofing.
  • Built-up felt: two or three layers of reinforced bitumen membrane laid to BS 8217, hard-wearing around plant and maintenance routes. Modern systems last 15–25 years, high-performance systems longer. See torch-on felt roofing.
  • Liquid-applied overlay: a reinforced coating that cures to one continuous layer, well suited to pipework, plant bases and awkward details. Indicative life 10–25+ years depending on the product. See liquid roofing.

Mastic asphalt suits concrete decks and walkways, and EPDM suits simpler roofs with few penetrations. An overlay only works where the existing roof is dry and firmly bonded, so we check for wet insulation before recommending one (see overlay or strip).

Which towns in Powys do we cover?

Commercial flat roofing in Powys: questions

Which towns in Powys do you cover?

All of Powys. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a commercial flat roof cost in Powys?

£12,150–£20,050 for a 100 m² commercial roof in single-ply with insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which postcode areas do you cover in Powys?

All of Powys, including the LD, SY postcode areas. Send your full postcode and we'll confirm.

Can you re-roof while our premises stay open?

Usually, yes. We phase the work so each section is watertight before the team leaves site, keep entrances and fire exits clear, and agree working hours and deliveries with you first.

Can the cost be spread over more than one budget year?

Yes. We can price a phased programme with each section shown separately, starting with the most urgent areas, so you can plan the spend while the building stays protected.

Do you work on school roofs?

Yes, where the school or its managing body appoints its own contractor. If your procurement rules require a framework contractor, check that before asking us to quote.

Everything about commercial flat roofing → · All flat roofing in Powys →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price