- Guide price
- £12,150–£20,050
- Survey
- Free for new and replacement roofs
- Quote
- Fixed, in writing
- Coverage
- England, Wales, Scotland, NI
Wrexham at a glance
- Largest towns
- Wrexham, Rhosllannerchrugog, Brymbo
- Postcode areas
- LL
- Building control
- Wrexham County Borough Council
- Neighbouring areas
- Flintshire · Denbighshire · Conwy · Gwynedd
- Guide price region
- Wales (−8% on West Midlands rates)
How much does a commercial flat roof cost in Wrexham?
Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Commercial roof (100 m²), single-ply + insulation | £12,150–£20,050 |
| Condition survey and leak investigation | £140–£280 |
| Block of flats (150 m²), felt + insulation + scaffold | £14,300–£25,000 |
Which flat roofs are common in Wrexham?
Flat roofs in Wrexham sit on 1960s and 1970s link-detached houses with flat-roofed garages and porches, bungalows with flat-roofed side extensions and dormers and terraced streets with flat-roofed rear kitchens and bathrooms. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in Wales
Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Wrexham the application goes to Wrexham County Borough Council. More on the rules.
Which roofing system suits a commercial flat roof?
Single-ply membrane usually suits large, simple roofs; built-up felt suits roofs with heavy foot traffic, plant or complex detailing; and a liquid-applied overlay suits a sound roof that needs new waterproofing without a full strip-out.
- Single-ply (PVC, TPO or FPO): light and quick to lay over large areas, with hot-air welded laps and fixing or bonding designed for the site's wind uplift. Indicative life 25–35+ years. See single-ply roofing.
- Built-up felt: two or three layers of reinforced bitumen membrane laid to BS 8217, hard-wearing around plant and maintenance routes. Modern systems last 15–25 years, high-performance systems longer. See torch-on felt roofing.
- Liquid-applied overlay: a reinforced coating that cures to one continuous layer, well suited to pipework, plant bases and awkward details. Indicative life 10–25+ years depending on the product. See liquid roofing.
Mastic asphalt suits concrete decks and walkways, and EPDM suits simpler roofs with few penetrations. An overlay only works where the existing roof is dry and firmly bonded, so we check for wet insulation before recommending one (see overlay or strip).
How do you handle CDM, roof access and fragile surfaces?
Every job is planned under the Construction (Design and Management) Regulations 2015, or CDM (NI) 2016 in Northern Ireland, with a construction phase plan and a method statement for the roof.
As a commercial client you have duties under CDM too, including passing on information about the building, such as drawings, details of previous roof work and the asbestos register. Buildings put up before 2000 can contain asbestos, so we ask for the register or a refurbishment survey before pricing a strip-out. If asbestos is found, a licensed specialist surveys and removes it before we start.
Roofs and rooflights are treated as fragile until a competent person confirms otherwise. Edge protection goes up on every job, rooflights and fragile sheets are covered or fenced off, and we agree safe access before work starts: scaffold, a tower, a powered access platform or a fixed access point where one is suitable.
Which towns in Wrexham do we cover?
Commercial flat roofing in Wrexham: questions
Which towns in Wrexham do you cover?
All of Wrexham. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a commercial flat roof cost in Wrexham?
£12,150–£20,050 for a 100 m² commercial roof in single-ply with insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which council handles building control for a flat roof in Wrexham?
It depends on where the roof is: in Wrexham that's Wrexham County Borough Council. Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. We confirm which applies at the survey.
Can you re-roof while our premises stay open?
Usually, yes. We phase the work so each section is watertight before the team leaves site, keep entrances and fire exits clear, and agree working hours and deliveries with you first.
Can the cost be spread over more than one budget year?
Yes. We can price a phased programme with each section shown separately, starting with the most urgent areas, so you can plan the spend while the building stays protected.
Can our existing roof be overlaid instead of stripped?
Often, if the survey shows the existing covering is sound, dry and firmly bonded. Wet insulation, a soft deck or several old layers mean a strip-out is the better long-term answer.
Everything about commercial flat roofing → · All flat roofing in Wrexham →