Flat RoofingContractors

Roofs we replace and build

Dormer roofs in Washington

A dormer roof in Washington may be only a few square metres, but it sits high up and meets a tiled roof on several sides. That makes the edges the hard part. Our quotes for dormer roofs set out the access, the insulation, the membrane and every abutment, with building control handled where needed.

Rear box dormer with a grey GRP flat roof and anthracite cladding on a Victorian terraceComputer-generated example image

Washington at a glance

Postcode districts
NE37, NE38
Population
about 67,085 (GeoNames)
Council area
Sunderland City Council
Building approval
Sunderland City Council building control, or a registered building control approver
Nearest main town
Sunderland, about 5 miles
Guide price region
North East (−7% on West Midlands rates)

What does a dormer roof in Washington need?

High, exposed dormers in Washington take the full force of the wind and rain. Edge trims loosen, flashings lift and the felt at the drip edge cracks. Once the faults spread around the perimeter, a new roof with fresh trims usually lasts far longer than another round of repairs.

In a large town like Washington, flat roofs are commonly found on lock-up garage blocks on estates or bungalows with flat-roofed side extensions and dormers. England averages roughly 870 mm of rain a year; the North East is drier than the west but cold and windy near the coast, so wind uplift and freeze-thaw are in the specification.

How much does a new dormer roof cost in Washington?

At North East guide rates, an 8 m² GRP dormer roof including scaffold comes to £1,300–£2,450 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Dormer (8 m²), GRP, scaffold£1,300–£2,450
Single garage (18 m²), EPDM rubber£1,500–£2,600
Extension (20 m²), GRP, new deck + insulation£2,800–£5,000

Do I need building regulations approval for a dormer roof?

Usually, yes, if you are replacing most of the roof. A dormer roof sits over a heated room, so it counts as a thermal element, and renovating more than half of it normally means upgrading the insulation where feasible.

In England the renovation target is 0.16 W/m²K for homes, approved through building control or a competent person scheme. Wales usually needs approval for most re-roofing work. Scotland works through the council's building standards and, where required, a building warrant. Northern Ireland asks you to contact district council building control before starting.

Insulating above the deck raises the roof slightly. On a dormer, that extra height has to fit under the main roof tiles at the back edge, so the build-up is planned at survey. Re-covering a dormer that looks the same afterwards does not usually need planning permission, but a listed building or conservation area may bring extra controls. More on our building regulations page.

What's included?

  • Written workmanship guarantee, with building control handled where needed
  • New membrane, drip trims and back-edge abutment under the tiles
  • Warm-roof insulation and a vapour control layer
  • Strip-out of the old covering and deck repairs

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Dormer roofs in Washington: questions

Do you cover Washington?

Yes. Washington is part of our Tyne and Wear coverage, including postcode districts NE37, NE38. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Washington?

Where the work needs approval it goes to Sunderland City Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a new dormer roof cost in Washington?

£1,300–£2,450 for an 8 m² GRP dormer roof including scaffold, at North East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Will insulating my dormer roof make it higher?

Yes, by the insulation thickness. We plan the build-up so the new roof still sits correctly under the main roof tiles at the back edge.

Why does my dormer leak at the back where it meets the roof?

That junction is the most common leak point, usually because the upstand or flashing under the tiles has failed. A proper re-roof rebuilds it.

Other flat roof work in Washington

Dormer roofs in Washington: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price