Dormer roofs across West Yorkshire

Guide price

£1,350–£2,500

Survey

Free for new and replacement roofs

Quote

Fixed, in writing

Coverage

England, Wales, Scotland, NI

How much does a new dormer roof cost in West Yorkshire?

Guide prices including VAT at Yorkshire and the Humber rates. The fixed price comes after a free survey for new and replacement roofs.

Which flat roofs are common in West Yorkshire?

Flat roofs in West Yorkshire sit on terraced streets with flat-roofed rear kitchens and bathrooms, 1960s and 1970s link-detached houses with flat-roofed garages and porches and shops with flat-roofed rear stores below flats. England averages roughly 870 mm of rain a year; the Pennine side of Yorkshire is wetter and windier than the east, so we specify for the site rather than the county. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in England

Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In West Yorkshire the application goes to Leeds City Council, City of Bradford Metropolitan District Council, Kirklees Council and 2 other councils. More on the rules.

Do I need building regulations approval for a dormer roof?

Usually, yes, if you are replacing most of the roof. A dormer roof sits over a heated room, so it counts as a thermal element, and renovating more than half of it normally means upgrading the insulation where feasible.

In England the renovation target is 0.16 W/m²K for homes, approved through building control or a competent person scheme. Wales usually needs approval for most re-roofing work. Scotland works through the council's building standards and, where required, a building warrant. Northern Ireland asks you to contact district council building control before starting.

Insulating above the deck raises the roof slightly. On a dormer, that extra height has to fit under the main roof tiles at the back edge, so the build-up is planned at survey. Re-covering a dormer that looks the same afterwards does not usually need planning permission, but a listed building or conservation area may bring extra controls. More on our building regulations page.

Why is scaffold and tile detailing so important on a dormer?

Because a dormer roof is high, small and surrounded by a pitched tiled roof, most failures happen at the edges rather than in the middle. Safe access is what allows those edges to be done properly.

Ladders alone do not give a safe working platform at that height, and every roof is treated as fragile until a competent person confirms otherwise. Scaffold with edge protection lets the team work along the front and sides of the dormer, and reach the junction with the main roof.

The back of the dormer is where most leaks start. The new membrane has to turn up under the tiles or slates, with a flashing that sheds water over it. Where the old detail used lead, we reinstate or replace it. Small roofs also leave little room for error at the drip edge: the front trim must throw water clear of the window frame and fascia, and any gutter has to be big enough for the area it drains. Dormer cheeks with tile hanging or cladding are checked for gaps that let water behind.

If you are also planning insulation upgrades or work on the main roof, tell us at survey so the scaffold can be shared.

Which towns in West Yorkshire do we cover?

• Leeds
• Bradford
• Huddersfield
• Wakefield
• Halifax
• Dewsbury
• Morley
• Keighley
• Castleford
• Pontefract
• Yeadon
• Brighouse
• Shipley
• Cleckheaton
• Pudsey
• Lofthouse
• Ossett
• Liversedge
• Horsforth
• South Elmsall
• Mirfield
• Chapel Allerton
• Bingley
• Kippax
• Elland

Everything about dormer roofs → · All flat roofing in West Yorkshire →