Flat RoofingContractors

Flat roof systems

EPDM rubber roofing across Conwy

We fit EPDM rubber roofing across Conwy, on everything from single garages to insulated extension roofs and dormers. Each job begins with a free survey and ends with a written workmanship guarantee. Prices on this page are guide figures for the region; your fixed price comes in writing once a surveyor has checked the deck, falls, upstands and access.

Roofer unrolling a single sheet of black EPDM membrane over a new OSB deck on a garage roofComputer-generated example image
Price per m²
£60–£106
Typical life
25–50 years
Manufacturer guarantees
20-year material warranties are common
Typical garage roof
£1,450–£2,600

Conwy at a glance

Largest towns
Colwyn Bay, Llandudno, Abergele
Postcode areas
LL
Building control
Conwy County Borough Council
Neighbouring areas
Denbighshire · Gwynedd · Flintshire · Wrexham
Guide price region
Wales (−8% on West Midlands rates)

How much does an EPDM rubber roof cost in Conwy?

Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500
Porch or bay (4 m²), EPDM£700–£1,150

Which flat roofs are common in Conwy?

Flat roofs in Conwy sit on shops with flat-roofed rear stores below flats, 1960s and 1970s link-detached houses with flat-roofed garages and porches and newer estates where the first extension roofs are now being replaced. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in Wales

Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Conwy the application goes to Conwy County Borough Council. More on the rules.

How long does an EPDM roof last, and what guarantees come with it?

A well-specified EPDM roof typically lasts 25 to 50 years, and one BBA assessment of an EPDM membrane puts its expected life at 35 years or more. Problems usually come from poorly bonded upstands, damaged trims or ponding, rather than the rubber itself.

Three separate documents can sit behind an EPDM roof:

  • Manufacturer material guarantee: covers the membrane and, on some systems, the wider build-up. Many need registration and a specified build-up, so we register it for you where the system allows.
  • Our written workmanship guarantee: given on every re-roof, with the length set out in your quote.
  • Insurance-backed guarantee: an option worth asking about if you want cover that does not depend on the contractor still trading.

A BBA certificate is an assessment of the product, not a guarantee. Our guide to flat roof guarantees explains the differences, and the lifespan guide compares EPDM with the other systems.

Do I need building regulations approval to replace a roof with EPDM?

Often, yes. In England, Wales and Northern Ireland, re-covering more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof should be insulated towards the renovation standard where that is feasible; in Scotland, the council's building standards service decides whether a building warrant is needed.

An unheated detached garage normally falls outside these rules, and a patch repair is treated differently from a full re-cover.

In practice that means a warm roof: insulation above the deck, a vapour control layer beneath it and the EPDM on top. The extra thickness lifts the finished roof, so at survey we check door thresholds, window cills, wall flashings and upstand heights, aiming for an upstand of about 150 mm above the finished surface. Where approval is needed, we deal with building control or building standards for you. The building regulations page and our warm vs cold roof guide go into more detail.

Which towns in Conwy do we cover?

EPDM rubber roofing in Conwy: questions

Which towns in Conwy do you cover?

All of Conwy. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does an EPDM rubber roof cost in Conwy?

£1,450–£2,600 for a typical 18 m² garage roof in EPDM, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which postcode areas do you cover in Conwy?

All of Conwy, including the LL postcode areas. Send your full postcode and we'll confirm.

Can you put a green roof on top of EPDM?

Yes. EPDM is often used under sedum, with a protection layer, drainage and growing medium laid on top. The structure must be able to carry the extra weight, which we check before quoting.

Does an EPDM roof need maintenance?

Very little. Clear leaves from outlets and gutters, look over trims and upstands once or twice a year and after storms, and keep foot traffic to a minimum.

Can a punctured EPDM roof be repaired?

Usually, yes. The area is cleaned and primed, then an EPDM patch or cover tape is bonded over the damage. If water has reached the deck, a survey first is sensible.

Everything about EPDM rubber roofing → · All flat roofing in Conwy →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price