Flat RoofingContractors

Flat roof systems

EPDM rubber roofing in Oldham

Rubber roofing for Oldham homes, landlords and small businesses: we strip, insulate where needed and re-cover flat roofs in EPDM, then finish the edges, outlets and wall upstands carefully. You deal with one contractor from survey to sign-off, and you get a written workmanship guarantee on every re-roof.

Roofer unrolling a single sheet of black EPDM membrane over a new OSB deck on a garage roofComputer-generated example image

Oldham at a glance

Postcode districts
M35, OL1, OL2, OL3, OL4, OL8, OL9
Population
about 237,110 (GeoNames)
Council area
Oldham Council
Building approval
Oldham Council building control, or a registered building control approver
Nearest main town
Manchester, about 6 miles
Guide price region
North West (−5% on West Midlands rates)

Why choose EPDM rubber roofing in Oldham?

Where an older flat roof in Oldham has a sound structure but a tired covering, EPDM is a straightforward upgrade: strip, check the deck, add a warm-roof build-up if the room below is heated, and bond the new membrane. It also makes a good base for a sedum green roof.

Around Oldham, flat roofs are common on bungalows with flat-roofed side extensions and dormers and on terraced streets with flat-roofed rear kitchens and bathrooms. The North West is one of England's wetter regions, averaging roughly 1,290 mm of rain a year, so falls, outlets and well-detailed upstands matter more than the membrane colour.

How much does an EPDM rubber roof cost in Oldham?

At North West guide rates, a typical 18 m² garage roof in EPDM comes to £1,500–£2,650 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), EPDM rubber£1,500–£2,650
Extension (20 m²), EPDM, new deck + insulation£2,650–£4,650
Porch or bay (4 m²), EPDM£700–£1,200

How are the joins, edges and upstands made watertight on an EPDM roof?

They are bonded with contact adhesive and sealed with purpose-made EPDM tapes and pre-formed pieces, because the edges and details are where most rubber roof leaks start.

  • Wall upstands: the rubber is turned up the wall, usually to about 150 mm above the finished roof, fully bonded, then finished with a termination bar or a cover flashing chased into the masonry.
  • Corners: folded rather than cut where possible, or finished with pre-formed pieces.
  • Joins: on roofs wider than one sheet, the laps are cleaned, primed and joined with splice tape, then rolled firmly.
  • Pipes and vents: sealed with pre-formed pipe boots rather than relying on mastic.
  • Edges and outlets: drip and kerb trims are fixed and the junction with the membrane is sealed with cover tape; outlets are bonded into the membrane at the lowest point.

We also check the falls before laying, because standing water around an outlet shortens the life of any detail. There is more on this in our pages on edges and drainage and rooflight upstands.

What's included?

  • Deck check and replacement of soft or rotten boards
  • Written workmanship guarantee, plus manufacturer guarantee registration where available
  • Warm-roof insulation and vapour control layer where required
  • Strip-out of the old covering, with waste taken away

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

EPDM rubber roofing in Oldham: questions

Do you cover Oldham?

Yes. Oldham is part of our Greater Manchester coverage, including postcode districts M35, OL1, OL2, OL3, OL4, OL8 and 1 more. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Oldham?

Where the work needs approval it goes to Oldham Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does an EPDM rubber roof cost in Oldham?

£1,500–£2,650 for a typical 18 m² garage roof in EPDM, at North West guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can an EPDM roof be fitted in winter?

Yes, as long as the deck is dry. The adhesives are affected by cold and damp, so very cold or wet days can delay bonding, and the roof is kept temporarily weathertight between dry spells.

Can you put a green roof on top of EPDM?

Yes. EPDM is often used under sedum, with a protection layer, drainage and growing medium laid on top. The structure must be able to carry the extra weight, which we check before quoting.

Other flat roof work in Oldham

EPDM rubber roofing in Oldham: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price