Earl Shilton at a glance
- Postcode districts
- LE9
- Population
- about 19,578 (GeoNames)
- Council area
- Hinckley and Bosworth Borough Council
- Building approval
- Hinckley and Bosworth Borough Council building control, or a registered building control approver
- Nearest main town
- Nuneaton, about 7 miles
- Guide price region
- East Midlands (−2% on West Midlands rates)
Why choose EPDM rubber roofing in Earl Shilton?
If your Earl Shilton roof has been patched more than once and the felt is cracking or blistering, a full replacement in EPDM can be better value than another repair. The rubber stays flexible through hot summers and freezing nights, and the replacement is the right point to bring the insulation up to standard.
Earl Shilton's flat roofs are mostly on 1930s semis with flat-roofed garages and kitchen extensions, with plenty on bungalows with flat-roofed side extensions and dormers too. The East Midlands is drier than the west of Britain, so most flat roofs here fail through age, UV and poor detailing at upstands rather than sheer rainfall.
How much does an EPDM rubber roof cost in Earl Shilton?
For Earl Shilton we use East Midlands rates: £1,550–£2,750 is the guide for a typical 18 m² garage roof in EPDM, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), EPDM rubber | £1,550–£2,750 |
| Extension (20 m²), EPDM, new deck + insulation | £2,750–£4,800 |
| Porch or bay (4 m²), EPDM | £750–£1,250 |
Do I need building regulations approval to replace a roof with EPDM?
Often, yes. In England, Wales and Northern Ireland, re-covering more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof should be insulated towards the renovation standard where that is feasible; in Scotland, the council's building standards service decides whether a building warrant is needed.
An unheated detached garage normally falls outside these rules, and a patch repair is treated differently from a full re-cover.
In practice that means a warm roof: insulation above the deck, a vapour control layer beneath it and the EPDM on top. The extra thickness lifts the finished roof, so at survey we check door thresholds, window cills, wall flashings and upstand heights, aiming for an upstand of about 150 mm above the finished surface. Where approval is needed, we deal with building control or building standards for you. The building regulations page and our warm vs cold roof guide go into more detail.
What's included?
- Deck check and replacement of soft or rotten boards
- Strip-out of the old covering, with waste taken away
- Written workmanship guarantee, plus manufacturer guarantee registration where available
- EPDM membrane fully bonded, in one sheet where the roof size allows
Building regulations in England
Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.
Which nearby areas do we also cover?
EPDM rubber roofing in Earl Shilton: questions
Do you cover Earl Shilton?
Yes. Earl Shilton is part of our Leicestershire coverage, including postcode districts LE9. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Earl Shilton?
Where the work needs approval it goes to Hinckley and Bosworth Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does an EPDM rubber roof cost in Earl Shilton?
£1,550–£2,750 for a typical 18 m² garage roof in EPDM, at East Midlands guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
How long does it take to fit an EPDM roof?
A single garage typically takes one to two days and an insulated extension roof two to three, weather permitting. Larger roofs, scaffold and complex details add time.
Can a punctured EPDM roof be repaired?
Usually, yes. The area is cleaned and primed, then an EPDM patch or cover tape is bonded over the damage. If water has reached the deck, a survey first is sensible.