Flat RoofingContractors

Flat roof systems

EPDM rubber roofing across Renfrewshire

Replacing a flat roof in Renfrewshire with EPDM? We work at addresses across the area, stripping the old covering, repairing or renewing the deck and bonding a new rubber membrane with properly formed details. Use the guide-price tool for a starting figure, then book a free survey for a fixed quote with no obligation.

Roofer unrolling a single sheet of black EPDM membrane over a new OSB deck on a garage roofComputer-generated example image
Price per m²
£62–£109
Typical life
25–50 years
Manufacturer guarantees
20-year material warranties are common
Typical garage roof
£1,500–£2,650

Renfrewshire at a glance

Largest towns
Paisley, Renfrew, Johnstone, Erskine
Postcode areas
PA
Building standards
Renfrewshire Council
Neighbouring areas
West Dunbartonshire · East Renfrewshire · Glasgow City · East Dunbartonshire
Guide price region
Scotland (−5% on West Midlands rates)

How much does an EPDM rubber roof cost in Renfrewshire?

Guide prices including VAT at Scotland rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), EPDM rubber£1,500–£2,650
Extension (20 m²), EPDM, new deck + insulation£2,650–£4,650
Porch or bay (4 m²), EPDM£700–£1,200

Which flat roofs are common in Renfrewshire?

Flat roofs in Renfrewshire sit on shops with flat-roofed rear stores below flats, 1960s and 1970s link-detached houses with flat-roofed garages and porches and bungalows with flat-roofed side extensions and dormers. Scotland averages roughly 1,570 mm of rain a year, with the west far wetter than the east, so drainage, falls and wind uplift are part of every specification we write. Approximate 1991–2020 regional averages based on Met Office data.

Building standards in Scotland

In Scotland a building warrant is usually needed for alterations, structural work and new roofs; like-for-like repairs to a covering can be exempt. Section 6 of the technical handbooks sets a domestic roof benchmark of 0.12 W/m²K, applied as far as reasonably practicable on an existing roof. In Renfrewshire the application goes to Renfrewshire Council (building standards). More on the rules.

How are the joins, edges and upstands made watertight on an EPDM roof?

They are bonded with contact adhesive and sealed with purpose-made EPDM tapes and pre-formed pieces, because the edges and details are where most rubber roof leaks start.

  • Wall upstands: the rubber is turned up the wall, usually to about 150 mm above the finished roof, fully bonded, then finished with a termination bar or a cover flashing chased into the masonry.
  • Corners: folded rather than cut where possible, or finished with pre-formed pieces.
  • Joins: on roofs wider than one sheet, the laps are cleaned, primed and joined with splice tape, then rolled firmly.
  • Pipes and vents: sealed with pre-formed pipe boots rather than relying on mastic.
  • Edges and outlets: drip and kerb trims are fixed and the junction with the membrane is sealed with cover tape; outlets are bonded into the membrane at the lowest point.

We also check the falls before laying, because standing water around an outlet shortens the life of any detail. There is more on this in our pages on edges and drainage and rooflight upstands.

Which towns in Renfrewshire do we cover?

EPDM rubber roofing in Renfrewshire: questions

Which towns in Renfrewshire do you cover?

All of Renfrewshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does an EPDM rubber roof cost in Renfrewshire?

£1,500–£2,650 for a typical 18 m² garage roof in EPDM, at Scotland guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which postcode areas do you cover in Renfrewshire?

All of Renfrewshire, including the PA postcode areas. Send your full postcode and we'll confirm.

Can a punctured EPDM roof be repaired?

Usually, yes. The area is cleaned and primed, then an EPDM patch or cover tape is bonded over the damage. If water has reached the deck, a survey first is sensible.

Does an EPDM roof need maintenance?

Very little. Clear leaves from outlets and gutters, look over trims and upstands once or twice a year and after storms, and keep foot traffic to a minimum.

How long does it take to fit an EPDM roof?

A single garage typically takes one to two days and an insulated extension roof two to three, weather permitting. Larger roofs, scaffold and complex details add time.

Everything about EPDM rubber roofing → · All flat roofing in Renfrewshire →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price