Flat RoofingContractors

Flat roof systems

EPDM rubber roofing in Galashiels

In Galashiels and across Scottish Borders, our teams fit EPDM rubber roofing to homes and small commercial buildings. The old covering is stripped, the deck is checked and repaired, insulation is added where the regulations call for it, and a new rubber membrane is bonded down with properly formed upstands and trims.

Roofer unrolling a single sheet of black EPDM membrane over a new OSB deck on a garage roofComputer-generated example image

Galashiels at a glance

Postcode districts
TD1
Population
about 10,060 (GeoNames)
Council area
Scottish Borders Council
Building approval
Scottish Borders Council building standards
Nearest main town
Hawick, about 13 miles
Guide price region
Scotland (−5% on West Midlands rates)

Why choose EPDM rubber roofing in Galashiels?

EPDM makes sense for a property in Galashiels when the roof is a straightforward shape, such as a garage or rear extension, and nobody needs to walk on it. A single sheet leaves few joins to fail, and because it is cold-applied there is no naked flame near timber fascias or a lived-in home.

In and around Galashiels, flat roofs are typically found on bungalows with flat-roofed side extensions and dormers, and on shops with flat-roofed rear stores below flats. Scotland averages roughly 1,570 mm of rain a year, with the west far wetter than the east, so drainage, falls and wind uplift are part of every specification we write.

How much does an EPDM rubber roof cost in Galashiels?

For Galashiels we use Scotland rates: £1,500–£2,650 is the guide for a typical 18 m² garage roof in EPDM, VAT included. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), EPDM rubber£1,500–£2,650
Extension (20 m²), EPDM, new deck + insulation£2,650–£4,650
Porch or bay (4 m²), EPDM£700–£1,200

How are the joins, edges and upstands made watertight on an EPDM roof?

They are bonded with contact adhesive and sealed with purpose-made EPDM tapes and pre-formed pieces, because the edges and details are where most rubber roof leaks start.

  • Wall upstands: the rubber is turned up the wall, usually to about 150 mm above the finished roof, fully bonded, then finished with a termination bar or a cover flashing chased into the masonry.
  • Corners: folded rather than cut where possible, or finished with pre-formed pieces.
  • Joins: on roofs wider than one sheet, the laps are cleaned, primed and joined with splice tape, then rolled firmly.
  • Pipes and vents: sealed with pre-formed pipe boots rather than relying on mastic.
  • Edges and outlets: drip and kerb trims are fixed and the junction with the membrane is sealed with cover tape; outlets are bonded into the membrane at the lowest point.

We also check the falls before laying, because standing water around an outlet shortens the life of any detail. There is more on this in our pages on edges and drainage and rooflight upstands.

What's included?

  • Deck check and replacement of soft or rotten boards
  • New drip and kerb trims, outlets and upstand details
  • Written workmanship guarantee, plus manufacturer guarantee registration where available
  • EPDM membrane fully bonded, in one sheet where the roof size allows

Building standards in Scotland

In Scotland the building standards technical handbooks (Section 6 for energy) apply, and the council's building standards service decides whether a building warrant is needed. Like-for-like repairs to a roof covering can be exempt; alterations, structural work and new roofs usually need a warrant before work starts. The domestic roof benchmark is 0.12 W/m²K, applied as far as reasonably practicable on an existing roof. More on the rules.

Which nearby areas do we also cover?

EPDM rubber roofing in Galashiels: questions

Do you cover Galashiels?

Yes. Galashiels is part of our Scottish Borders coverage, including postcode districts TD1. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building standards for a flat roof in Galashiels?

Where the work needs approval it goes to Scottish Borders Council building standards. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does an EPDM rubber roof cost in Galashiels?

£1,500–£2,650 for a typical 18 m² garage roof in EPDM, at Scotland guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can an EPDM roof be fitted in winter?

Yes, as long as the deck is dry. The adhesives are affected by cold and damp, so very cold or wet days can delay bonding, and the roof is kept temporarily weathertight between dry spells.

Can you put a green roof on top of EPDM?

Yes. EPDM is often used under sedum, with a protection layer, drainage and growing medium laid on top. The structure must be able to carry the extra weight, which we check before quoting.

Other flat roof work in Galashiels

EPDM rubber roofing in Galashiels: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price