Flat RoofingContractors

Roofs we replace and build

Extension and kitchen roofs in Bedford

We replace kitchen, dining and rear extension roofs in Bedford using EPDM, GRP or torch-on felt over a warm-roof build-up. Each quote lists the deck, insulation, membrane and upstands in writing, so you can compare it properly. A written workmanship guarantee covers every re-roof.

Single-storey kitchen extension with a flat roof, roof lantern and open bi-fold doorsComputer-generated example image

Bedford at a glance

Postcode districts
MK40, MK41
Population
about 106,940 (GeoNames)
Council area
Bedford Borough Council
Building approval
Bedford Borough Council building control, or a registered building control approver
Nearest main town
Milton Keynes, about 14 miles
Guide price region
East of England (+5% on West Midlands rates)

What makes a good extension roof in Bedford?

Extension roofs in Bedford are often replaced because the original was built cheaply: thin chipboard decks, little or no insulation and felt turned up the wall without a proper flashing. Twenty or thirty years on, those weaknesses show up as leaks at the back wall and a cold, damp ceiling.

Bedford's flat roofs are mostly on 1930s semis with flat-roofed garages and kitchen extensions, with plenty on low-rise post-war blocks of flats too. The East of England is the driest part of Britain, with parts of the Anglian region around 630 mm a year, so summer heat and UV, not rainfall, do most of the ageing on a felt roof.

How much does a new extension roof cost in Bedford?

Guide price in Bedford: £2,950–£5,150 for a 20 m² extension roof in EPDM with a new deck and insulation, including VAT at East of England rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Extension (20 m²), EPDM, new deck + insulation£2,950–£5,150
Extension (20 m²), GRP, new deck + insulation£3,150–£5,650
Extension (20 m²), EPDM, insulation + 1 rooflight upstand£3,150–£5,500
Single garage (18 m²), EPDM rubber£1,700–£2,950

Why does water pond or leak where the extension meets the house?

Usually because the fall runs the wrong way, the abutment detail has failed, or the roof has sagged close to the wall. The junction with the house is the most common leak point on an extension roof.

If the roof falls towards the house, or the deck dips near the wall, water sits against the upstand and finds any weakness in the flashing above. Older roofs often have the felt simply turned up the brickwork with no cover flashing, or a flashing that has pulled out of its joint. A patch will not change a fall. We re-firr or use tapered insulation so water runs away from the wall, then form a new upstand, usually 150 mm above the finished roof, with a flashing chased into the mortar joint.

Rooflights and lanterns are the other weak point. A lantern needs a properly built kerb with the membrane dressed up and under its frame. We rebuild rooflight upstands within the roof job; we do not supply the lantern itself. Our guide to ponding water explains the causes in more depth.

What's included?

  • Free survey of the roof, abutment and room below
  • Falls set away from the house wall
  • New abutment upstand and flashing, plus rebuilt rooflight kerbs
  • Staged strip-out so the room stays weathertight

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Extension and kitchen roofs in Bedford: questions

Do you cover Bedford?

Yes. Bedford is part of our Bedfordshire coverage, including postcode districts MK40, MK41. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Bedford?

Where the work needs approval it goes to Bedford Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a new extension roof cost in Bedford?

£2,950–£5,150 for a 20 m² extension roof in EPDM with a new deck and insulation, at East of England guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can a sedum roof go on my extension?

Possibly, if the structure can carry the extra weight and the roof has suitable falls and drainage. We check the joists at survey before recommending it.

Is EPDM or GRP better for a kitchen extension?

Neither is better in every case. EPDM suits simple rectangular roofs with few details, while GRP is often chosen where there are rooflights, corners or occasional foot traffic.

Other flat roof work in Bedford

Extension and kitchen roofs in Bedford: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price