- Guide price
- £140–£480
- Repair price
- Confirmed once the leak or damage is found
- Condition survey report
- £140–£290
- Coverage
- England, Wales, Scotland, NI
Greater Manchester at a glance
- Largest towns
- Manchester, Oldham, Wigan, Bolton
- Postcode areas
- BL, M, OL, SK, WA, WN
- Building control
- Manchester City Council, Oldham Council, Wigan Council and 7 other councils
- Neighbouring areas
- Cheshire · Lancashire · Merseyside · West Yorkshire
- Guide price region
- North West (−5% on West Midlands rates)
How much does a flat roof repair cost in Greater Manchester?
Guide prices including VAT at North West rates. We confirm the price once we've traced the leak or seen the damage.
| Job | Guide price inc VAT |
|---|---|
| Localised patch repair | £140–£480 |
| Upstand or flashing repair | £240–£620 |
| Outlet or drainage repair | £110–£330 |
| Emergency temporary weatherproofing visit | £170–£430 |
| Condition survey and leak investigation | £140–£290 |
Which flat roofs are common in Greater Manchester?
Flat roofs in Greater Manchester sit on low-rise post-war blocks of flats, newer estates where the first extension roofs are now being replaced and bungalows with flat-roofed side extensions and dormers. The North West is one of England's wetter regions, averaging roughly 1,290 mm of rain a year, so falls, outlets and well-detailed upstands matter more than the membrane colour. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in England
Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Greater Manchester the application goes to Manchester City Council, Oldham Council, Wigan Council and 7 other councils. More on the rules.
Which repair materials work with my type of flat roof?
The repair has to use the same system as the roof, because many flat roof materials don't bond to each other and some damage each other.
- Torch-on felt: repaired with compatible bitumen membrane, cut back to sound felt and lapped well beyond the defect. Torching near timber, insulation or fascias needs care, and some details are better done with cold-applied methods.
- EPDM rubber: repaired with EPDM patches and the manufacturer's primer and seam tape. Bitumen products and many general-purpose sealants won't bond to EPDM and shouldn't be used on it.
- GRP fibreglass: the area is ground back, then new resin and glass matting are laid and finished with topcoat to match.
- Liquid-applied and single-ply: repaired with the same manufacturer's products wherever possible, as mixing systems can affect a material guarantee.
- Mastic asphalt: cracks and blisters are cut out and made good with new asphalt by an operative who works with it.
A tin of roof sealant or bitumen paint may stop a drip for a while, but on the wrong membrane it makes a proper repair harder later.
Why does a flat roof leak in one place but drip somewhere else?
Because water rarely comes through the ceiling directly below the hole. It gets in at one point, runs along the deck, a joist or the top of the insulation, and drips wherever it finds a low spot or a gap in the ceiling.
That is why a patch over the damp patch so often fails. Before we repair anything, we work back from the stain to the likely entry point and check the usual weak spots: upstands where the roof meets a wall, flashings and cavity trays above them, laps and seams, outlets and gutters, drip trims, rooflight kerbs, and any fixings or cables that pass through the covering. The fault is frequently at an edge or a wall rather than in the middle of the roof.
Sometimes the cause isn't the roof at all. Defective pointing, a failed cavity tray or a cracked coping above the roof can let water in behind the upstand, and condensation in a cold roof can look exactly like a leak. Our guide to flat roof leaks covers these causes. If the path can't be found by inspection, a leak tracing survey is the next step.
Which towns in Greater Manchester do we cover?
- Manchester
- Oldham
- Wigan
- Bolton
- Stockport
- Salford
- Rochdale
- Sale
- Bury
- Altrincham
- Middleton
- Ashton-under-Lyne
- Leigh
- Stretford
- Urmston
- Eccles
- Tyldesley
- Hyde
- Walkden
- Prestwich
- Radcliffe
- Cheadle Hulme
- Heywood
- Denton
- Stalybridge
- Ashton in Makerfield
- Westhoughton
- Farnworth
- Saddleworth
- Hindley
- Golborne
- Droylsden
- Royton
- Failsworth
- Hazel Grove
- Irlam
- Horwich
- Bramhall
- Ramsbottom
- Bredbury
- Longsight
Flat roof repairs in Greater Manchester: questions
Which towns in Greater Manchester do you cover?
All of Greater Manchester. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a flat roof repair cost in Greater Manchester?
£140–£480 for a localised patch repair, at North West guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.
Which postcode areas do you cover in Greater Manchester?
All of Greater Manchester, including the BL, M, OL, SK, WA, WN postcode areas. Send your full postcode and we'll confirm.
How long does a flat roof repair take?
Most small repairs take a few hours on site once the roof is dry. Larger upstand or outlet repairs can take a day or more, and setting up scaffold or access equipment adds time.
Do I need building regulations approval for a flat roof repair?
Not usually for a patch repair. Replacing a large part of the covering over a heated room is treated differently and can bring in the thermal upgrade rules.
Will a repair affect my roof's guarantee?
It can. If the roof is still under a manufacturer's material guarantee, the repair should normally use that manufacturer's products and methods, so share any guarantee paperwork with us before work starts.
Everything about flat roof repairs → · All flat roofing in Greater Manchester →