Flat RoofingContractors

Repairs and surveys

Flat roof repairs in Doncaster

In Doncaster, as anywhere, a flat roof rarely leaks right above the stain. That is why our repairs begin by tracing the water back to where it gets in, whether that's an upstand, a lap, an outlet or a wall above the roof, before we cut back to sound material and repair it properly.

Roofer cutting out a blister on an old mineral felt flat roof before a patch repairComputer-generated example image

Doncaster at a glance

Postcode districts
DN1, DN2, DN3, DN4, DN5, DN6, DN11, DN12
Population
about 113,566 (GeoNames)
Council area
City of Doncaster Council
Building approval
City of Doncaster Council building control, or a registered building control approver
Nearest main town
Rotherham, about 11 miles
Guide price region
Yorkshire and the Humber (−5% on West Midlands rates)

When is a repair the right answer in Doncaster?

In a place like Doncaster, flat roofs usually sit over garages, rear extensions, dormers and bays, and they take the full force of the weather with little margin for error. A single failed lap or a cracked upstand is enough to let water into a kitchen, bedroom or hallway below.

In and around Doncaster, flat roofs are typically found on newer estates where the first extension roofs are now being replaced, and on bungalows with flat-roofed side extensions and dormers. England averages roughly 870 mm of rain a year; the Pennine side of Yorkshire is wetter and windier than the east, so we specify for the site rather than the county.

How much does a flat roof repair cost in Doncaster?

Guide price in Doncaster: £140–£480 for a localised patch repair, including VAT at Yorkshire and the Humber rates. We confirm the price once we've traced the leak or seen the damage.

JobGuide price inc VAT
Localised patch repair£140–£480
Upstand or flashing repair£240–£620
Outlet or drainage repair£110–£330
Emergency temporary weatherproofing visit£170–£430
Condition survey and leak investigation£140–£290

Which repair materials work with my type of flat roof?

The repair has to use the same system as the roof, because many flat roof materials don't bond to each other and some damage each other.

  • Torch-on felt: repaired with compatible bitumen membrane, cut back to sound felt and lapped well beyond the defect. Torching near timber, insulation or fascias needs care, and some details are better done with cold-applied methods.
  • EPDM rubber: repaired with EPDM patches and the manufacturer's primer and seam tape. Bitumen products and many general-purpose sealants won't bond to EPDM and shouldn't be used on it.
  • GRP fibreglass: the area is ground back, then new resin and glass matting are laid and finished with topcoat to match.
  • Liquid-applied and single-ply: repaired with the same manufacturer's products wherever possible, as mixing systems can affect a material guarantee.
  • Mastic asphalt: cracks and blisters are cut out and made good with new asphalt by an operative who works with it.

A tin of roof sealant or bitumen paint may stop a drip for a while, but on the wrong membrane it makes a proper repair harder later.

What's included?

  • Outlets and gutters cleared while we're on the roof
  • Inspection of the whole roof, not just the wet patch
  • Fixed price confirmed in writing before work starts
  • Upstands, flashings, laps and seams made good

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Flat roof repairs in Doncaster: questions

Do you cover Doncaster?

Yes. Doncaster is part of our South Yorkshire coverage, including postcode districts DN1, DN2, DN3, DN4, DN5, DN6 and 2 more. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Doncaster?

Where the work needs approval it goes to City of Doncaster Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a flat roof repair cost in Doncaster?

£140–£480 for a localised patch repair, at Yorkshire and the Humber guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.

Do I need building regulations approval for a flat roof repair?

Not usually for a patch repair. Replacing a large part of the covering over a heated room is treated differently and can bring in the thermal upgrade rules.

How long does a flat roof repair take?

Most small repairs take a few hours on site once the roof is dry. Larger upstand or outlet repairs can take a day or more, and setting up scaffold or access equipment adds time.

Other flat roof work in Doncaster

Flat roof repairs in Doncaster: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price