- Guide price
- £2,600–£4,500
- Survey
- Free for new and replacement roofs
- Quote
- Fixed, in writing
- Coverage
- England, Wales, Scotland, NI
Pembrokeshire at a glance
- Largest towns
- Haverfordwest, Milford Haven, Pembroke Dock, Pembroke
- Postcode areas
- SA
- Building control
- Pembrokeshire County Council
- Neighbouring areas
- Carmarthenshire · Swansea · Neath Port Talbot · Bridgend
- Guide price region
- Wales (−8% on West Midlands rates)
How much does a flat roof replacement cost in Pembrokeshire?
Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
| Single garage (18 m²), torch-on felt | £1,400–£2,400 |
| Extension (20 m²), GRP, new deck + insulation | £2,750–£4,950 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
Which flat roofs are common in Pembrokeshire?
Flat roofs in Pembrokeshire sit on shops with flat-roofed rear stores below flats, 1960s and 1970s link-detached houses with flat-roofed garages and porches and newer estates where the first extension roofs are now being replaced. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in Wales
Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Pembrokeshire the application goes to Pembrokeshire County Council. More on the rules.
Do I need building regulations approval to replace a flat roof?
Often, yes. Replacing the covering of a flat roof over a heated room is usually treated as renovating a thermal element, which brings insulation requirements and, in most cases, approval.
In England, if more than half of that roof is renovated, the whole roof should be upgraded towards a U-value of 0.16 W/m²K for homes (0.18 for non-domestic buildings) where that is technically, functionally and economically feasible, judged against a simple payback of 15 years. Approval comes from building control or self-certification through a registered competent person scheme. Structural changes, or a covering that adds 15% or more to the roof's weight, also need approval.
The other nations differ: most re-roofing in Wales needs approval, Scotland works through building standards and the building warrant, and in Northern Ireland you contact the district council's building control first. An unheated detached garage is not normally a thermal element. Planning permission is not usually needed if the roof looks much the same afterwards, though listed buildings and conservation areas are different. We handle approvals where needed; see building regulations.
Should I overlay my old flat roof or strip it fully?
Strip it fully if the deck is soft, the insulation is wet or the falls are wrong; an overlay only suits a dry, sound roof that already drains well. Covering a wet roof traps the moisture, and rot carries on out of sight.
An overlay also raises the roof level, eating into upstand height at walls and door thresholds, and every layer adds weight. In England, a covering that adds 15% or more to the roof's weight needs building control approval. Signs it is time to replace rather than repair:
- ponding that lingers long after rain
- blisters, cracking or crazing across wide areas
- bare bitumen where the mineral chippings have gone
- split laps and lifted upstands or flashings
- damp ceilings, or a deck that has gone soft
- leaks that return after each repair
A single defect on an otherwise dry roof can usually be put right with a repair. If you're unsure, a survey settles it, and our guides to overlay or strip and repair or replace go further.
Which towns in Pembrokeshire do we cover?
Flat roof replacement in Pembrokeshire: questions
Which towns in Pembrokeshire do you cover?
All of Pembrokeshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a flat roof replacement cost in Pembrokeshire?
£2,600–£4,500 for a 20 m² extension roof in EPDM with a new deck and insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which council handles building control for a flat roof in Pembrokeshire?
It depends on where the roof is: in Pembrokeshire that's Pembrokeshire County Council. Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. We confirm which applies at the survey.
Will a new flat roof be better insulated than the old one?
If it is over a heated room, yes. A full replacement usually has to be upgraded towards current insulation levels where feasible, and we build it as a warm roof with the insulation above the deck.
Can you replace just part of a flat roof?
Sometimes, if the rest is sound and dry. Renovating more than half of a roof over a heated room usually brings the whole roof under the insulation rules, so a full replacement can make more sense.
Will a replacement make my roof higher?
Usually a little, if insulation is added above the deck. We check door thresholds, window sills, upstands and wall flashings at survey so the new level works.
Everything about flat roof replacement → · All flat roofing in Pembrokeshire →