Flat roof surveys and leak tracing across County Antrim

Guide price

£130–£260

Repair price

Confirmed once the leak or damage is found

Condition survey report

£130–£260

Coverage

England, Wales, Scotland, NI

How much does a flat roof survey cost in County Antrim?

Guide prices including VAT at Northern Ireland rates. We confirm the price once we've traced the leak or seen the damage.

Which flat roofs are common in County Antrim?

Flat roofs in County Antrim sit on 1960s and 1970s link-detached houses with flat-roofed garages and porches, bungalows with flat-roofed side extensions and dormers and newer estates where the first extension roofs are now being replaced. Northern Ireland averages roughly 1,150 mm of rain a year, spread over many wet days, so a roof that sheds water quickly to clear outlets lasts far longer than one that holds puddles. Approximate 1991–2020 regional averages based on Met Office data.

Building control in Northern Ireland

In Northern Ireland, renovating or replacing a roof over a heated room usually means meeting Technical Booklet F1, and building control should be contacted before work starts. Technical Booklet F1 sets roof insulation at 0.18 W/m²K when a roof over a heated room is renovated or newly built, where feasible. In County Antrim the application goes to Lisburn and Castlereagh City Council, Antrim and Newtownabbey Borough Council, Mid and East Antrim Borough Council and 1 other council. More on the rules.

How long does a flat roof survey take and how long is it valid?

A survey of a typical garage or extension roof usually takes an hour or two on site. Larger, higher or multi-area roofs take longer, and the written report follows afterwards.

A survey describes the roof on the day it was inspected. It stays a useful baseline for planning, but roofs change, particularly older ones and after a hard winter or a storm. If you are using a report to plan a replacement some time later, or after a fresh leak, a short follow-up check is sensible. For roofs you manage over the long term, a regular inspection backed by the maintenance checklist picks up problems early.

How do you find where a flat roof is leaking?

By working from the evidence inside back to the likely entry points outside, then confirming the path with moisture readings and, where needed, small test openings.

We start indoors, looking at where the staining is, when it appears and whether it follows rain, wind from one direction or cold weather. Then, on the roof, we check the details where most leaks start: upstands and flashings, laps and seams, outlets, gutters, edge trims, rooflight kerbs and anything that passes through the covering. Walls, copings and cavity trays above the roof are checked too, because water getting in behind an upstand can look like a roof leak.

A moisture meter shows where the covering, or the material beneath it, is holding water, and readings across the roof help map how far the wet has spread. Meter readings are a guide, not proof, so where they suggest a problem we may take a core sample: a small cut through the covering and insulation to see what is underneath and whether the deck is sound. The opening is sealed again with compatible material before we leave.

Condensation can also look like a leak, especially in older cold roofs without adequate ventilation, and the survey considers that possibility too. The flat roof leaks guide explains the common causes.

Which towns in County Antrim do we cover?

• Lisburn
• Newtownabbey
• Carrickfergus
• Ballymena
• Antrim
• Larne
• Ballymoney
• Ballyclare

Everything about flat roof surveys and leak tracing → · All flat roofing in County Antrim →