Flat RoofingContractors

Commercial and blocks

Flats, HMOs and block roofs across Bedfordshire

We replace and repair flat roofs on blocks of flats, converted houses and HMOs across Bedfordshire, for freeholders, landlords, managing agents and resident management companies. Replacement surveys are free, and every quote is itemised so it can be shared with leaseholders. Work is phased around residents, using long-life systems such as single-ply, mastic asphalt, EPDM and built-up felt.

1960s block of flats with scaffold and edge protection while its flat roof is replacedComputer-generated example image
Guide price
£16,350–£28,550
Survey
Free for new and replacement roofs
Quote
Fixed, in writing
Coverage
England, Wales, Scotland, NI

Bedfordshire at a glance

Largest towns
Luton, Bedford, Dunstable, Leighton Buzzard
Postcode areas
LU, MK, SG
Building control
Luton Borough Council, Bedford Borough Council and Central Bedfordshire Council
Neighbouring areas
Hertfordshire · Buckinghamshire · Northamptonshire · Cambridgeshire
Guide price region
East of England (+5% on West Midlands rates)

How much does a block or HMO roof cost in Bedfordshire?

Guide prices including VAT at East of England rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Block of flats (150 m²), felt + insulation + scaffold£16,350–£28,550
Commercial roof (100 m²), single-ply + insulation£13,900–£22,850

Which flat roofs are common in Bedfordshire?

Flat roofs in Bedfordshire sit on terraced streets with flat-roofed rear kitchens and bathrooms, newer estates where the first extension roofs are now being replaced and lock-up garage blocks on estates. The East of England is the driest part of Britain, with parts of the Anglian region around 630 mm a year, so summer heat and UV, not rainfall, do most of the ageing on a felt roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in England

Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Bedfordshire the application goes to Luton Borough Council, Bedford Borough Council and Central Bedfordshire Council. More on the rules.

How do you manage access and residents during the work?

We agree an access and communication plan with the agent or freeholder before the scaffold goes up, so residents know what is happening and when.

That usually covers notices in the common parts and letters to each flat, scaffold and skip positions, keeping entrances, escape routes and bin stores clear, working hours, securing the scaffold out of hours, and a named contact for questions. If we need to look at a ceiling inside a top-floor flat, we arrange access through the agent or landlord.

Occupied blocks are re-roofed in phases, with each section watertight before the team leaves site, which also lets a larger roof be spread over more than one service charge year. Hot works near windows, vents and escape routes are tightly controlled, or avoided altogether with cold-applied systems.

Do fire and insulation rules affect block roofs?

Yes. Where a roof is close to a boundary, building regulations limit which coverings can be used, and the build-up should carry a suitable external fire classification such as BROOF(t4); in England this is covered by Approved Document B.

BROOF(t4) applies to a tested build-up, so we check that the manufacturer's classification covers the deck, insulation and membrane actually being installed, not just the membrane name. Where the roof crosses a separating or compartment wall, the fire-stopping detail is kept intact.

Re-covering more than half of a roof over heated flats usually triggers the thermal element rules, so the insulation is upgraded towards the renovation U-value where feasible: 0.16 W/m²K for dwellings in England and Wales. We handle building control where it is needed. See building regulations and warm vs cold roofs.

Which towns in Bedfordshire do we cover?

Flats, HMOs and block roofs in Bedfordshire: questions

Which towns in Bedfordshire do you cover?

All of Bedfordshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a block or HMO roof cost in Bedfordshire?

£16,350–£28,550 for a 150 m² block-of-flats roof in felt with insulation and scaffold, at East of England guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which council handles building control for a flat roof in Bedfordshire?

It depends on where the roof is: in Bedfordshire that's Luton Borough Council, Bedford Borough Council and Central Bedfordshire Council. Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. We confirm which applies at the survey.

Do residents need to move out during a re-roof?

No. Block roofs are normally replaced with residents in place, and if we need to check a ceiling inside a top-floor flat, access is arranged through the agent or landlord.

Do you work for HMO landlords?

Yes. We replace and repair flat roofs on HMOs and converted flats, arrange access with tenants through the landlord or agent, and keep escape routes and entrances clear while we work.

Can a block roof be replaced in phases?

Yes. Larger roofs can be split into sections over one or more budget years, with each phase priced separately and each section left watertight before the team leaves site.

Everything about flats, HMOs and block roofs → · All flat roofing in Bedfordshire →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price