Flat RoofingContractors

Flat roof systems

GRP fibreglass roofing in Cirencester

Our GRP service in Cirencester covers full replacement of tired felt and failed fibreglass roofs, as well as new roofs on extensions. Every job includes deck checks, careful joint reinforcement and a UV-stable topcoat, with a written workmanship guarantee on every re-roof and manufacturer guarantees registered where the system allows.

Finished grey GRP fibreglass flat roof with moulded trims on a single-storey extensionComputer-generated example image

Cirencester at a glance

Postcode districts
GL7
Population
about 20,229 (GeoNames)
Council area
Cotswold District Council
Building approval
Cotswold District Council building control, or a registered building control approver
Nearest main town
Cheltenham, about 13 miles
Guide price region
South West (+3% on West Midlands rates)

Why choose GRP fibreglass roofing in Cirencester?

GRP is a good fit in Cirencester for roofs with awkward shapes, short runs of upstand and lots of corners, because every detail is laminated in place rather than cut and glued. Where a sheet membrane would need many joins, fibreglass forms one continuous skin across the whole roof.

In and around Cirencester, flat roofs are typically found on 1960s and 1970s link-detached houses with flat-roofed garages and porches, and on terraced streets with flat-roofed rear kitchens and bathrooms. The South West averages roughly 1,260 mm of rain a year and many roofs face wind off the Atlantic, so we specify fixings and edge details for wind uplift as well as drainage.

How much does a GRP fibreglass roof cost in Cirencester?

For Cirencester we use South West rates: £3,100–£5,550 is the guide for a 20 m² extension roof in GRP with a new deck and insulation, VAT included. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Extension (20 m²), GRP, new deck + insulation£3,100–£5,550
Dormer (8 m²), GRP, scaffold£1,450–£2,750
Single garage (18 m²), GRP fibreglass£1,850–£3,350
Single garage (18 m²), EPDM rubber£1,650–£2,900
Extension (20 m²), EPDM, new deck + insulation£2,900–£5,050

Why do GRP roofs crack, and can weather affect the installation?

GRP usually cracks where the structure moves and the laminate cannot, typically along board joints, at the junction with trims, or where a roof meets a wall. Weather during laying is the other big factor, because resin cures by chemical reaction and that reaction is sensitive to temperature and moisture.

How we reduce the risk of cracking:

  • boards fixed at close centres so the deck does not flex;
  • joints taped and reinforced with an extra strip of mat;
  • wall junctions finished with a separate trim or flashing, not laminated hard into the masonry;
  • roofs over a certain size divided with movement details where the system calls for them.

And how weather is managed:

  • no laminating in rain, on a damp deck, or when dew or frost is likely before the resin sets;
  • catalyst levels adjusted for the temperature, so resin neither stays tacky on a cold day nor kicks too fast in summer heat;
  • the roof sheeted over if a shower threatens a fresh laminate.

That is why a GRP date can move at short notice. A day's delay costs far less than a laminate that never cures properly.

What's included?

  • Warm-roof insulation and vapour control layer where the room below is heated
  • Removal of the old covering and disposal of waste
  • Resin and glass-mat laminate with taped and reinforced joints
  • Moulded GRP trims, kerbs and upstands

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

GRP fibreglass roofing in Cirencester: questions

Do you cover Cirencester?

Yes. Cirencester is part of our Gloucestershire coverage, including postcode districts GL7. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Cirencester?

Where the work needs approval it goes to Cotswold District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a GRP fibreglass roof cost in Cirencester?

£3,100–£5,550 for a 20 m² extension roof in GRP with a new deck and insulation, at South West guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Is GRP suitable for a dormer roof?

Yes, GRP is commonly used on dormers because the trims can be moulded neatly and the finish looks tidy from the ground. Scaffold is normally needed, which we include in the quote.

What colours does a GRP roof come in?

Topcoats are typically available in greys, greens, black and some other shades. Lighter colours absorb less heat, and an anti-slip finish can be added where people will walk on the roof.

Other flat roof work in Cirencester

GRP fibreglass roofing in Cirencester: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price