Flat RoofingContractors

Flat roof systems

GRP fibreglass roofing across Pembrokeshire

Need a fibreglass roof somewhere in Pembrokeshire? Start with the guide-price tool for a quick figure, then book a free survey. We check the structure, measure the roof, look at falls and upstands, and return a fixed price in writing. Each re-roof comes with a written workmanship guarantee, and the quote states how long it runs.

Finished grey GRP fibreglass flat roof with moulded trims on a single-storey extensionComputer-generated example image
Price per m²
£69–£129
Typical life
20–40 years
Manufacturer guarantees
20–25 year material warranties on specified systems
Typical garage roof
£1,650–£3,000

Pembrokeshire at a glance

Largest towns
Haverfordwest, Milford Haven, Pembroke Dock, Pembroke
Postcode areas
SA
Building control
Pembrokeshire County Council
Neighbouring areas
Carmarthenshire · Swansea · Neath Port Talbot · Bridgend
Guide price region
Wales (−8% on West Midlands rates)

How much does a GRP fibreglass roof cost in Pembrokeshire?

Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Extension (20 m²), GRP, new deck + insulation£2,750–£4,950
Dormer (8 m²), GRP, scaffold£1,300–£2,450
Single garage (18 m²), GRP fibreglass£1,650–£3,000
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500

Which flat roofs are common in Pembrokeshire?

Flat roofs in Pembrokeshire sit on 1960s and 1970s link-detached houses with flat-roofed garages and porches, shops with flat-roofed rear stores below flats and 1930s semis with flat-roofed garages and kitchen extensions. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in Wales

Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Pembrokeshire the application goes to Pembrokeshire County Council. More on the rules.

Why do GRP roofs crack, and can weather affect the installation?

GRP usually cracks where the structure moves and the laminate cannot, typically along board joints, at the junction with trims, or where a roof meets a wall. Weather during laying is the other big factor, because resin cures by chemical reaction and that reaction is sensitive to temperature and moisture.

How we reduce the risk of cracking:

  • boards fixed at close centres so the deck does not flex;
  • joints taped and reinforced with an extra strip of mat;
  • wall junctions finished with a separate trim or flashing, not laminated hard into the masonry;
  • roofs over a certain size divided with movement details where the system calls for them.

And how weather is managed:

  • no laminating in rain, on a damp deck, or when dew or frost is likely before the resin sets;
  • catalyst levels adjusted for the temperature, so resin neither stays tacky on a cold day nor kicks too fast in summer heat;
  • the roof sheeted over if a shower threatens a fresh laminate.

That is why a GRP date can move at short notice. A day's delay costs far less than a laminate that never cures properly.

Will a new GRP roof need extra insulation to meet building regulations?

If the roof is over a heated room and you are replacing more than half of it, usually yes. In England, Wales and Northern Ireland that counts as renovating a thermal element, and in Scotland the council's building standards service will say whether a building warrant applies.

GRP pairs well with a warm roof because the new deck boards it needs can sit on top of the insulation. The result is thicker, so we check at survey that there is room under door cills and wall flashings, and that the upstands can finish around 150 mm above the new surface. Where approval is needed we arrange it with building control or building standards.

Unheated, detached garages normally sit outside the thermal rules. See the building regulations page for each nation, or the warm vs cold roof guide for why we avoid cold roofs where we can.

Which towns in Pembrokeshire do we cover?

GRP fibreglass roofing in Pembrokeshire: questions

Which towns in Pembrokeshire do you cover?

All of Pembrokeshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a GRP fibreglass roof cost in Pembrokeshire?

£2,750–£4,950 for a 20 m² extension roof in GRP with a new deck and insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which postcode areas do you cover in Pembrokeshire?

All of Pembrokeshire, including the SA postcode areas. Send your full postcode and we'll confirm.

Can a cracked GRP roof be repaired?

Often, yes. The area is ground back, cleaned and re-laminated with fresh mat and topcoat. If cracks keep returning along joints, the deck or detailing usually needs attention rather than another patch.

Can GRP be laid over an existing felt roof?

Generally no. GRP needs a clean, dry, rigid timber deck, so the old felt is usually stripped and the boards replaced before laminating.

What colours does a GRP roof come in?

Topcoats are typically available in greys, greens, black and some other shades. Lighter colours absorb less heat, and an anti-slip finish can be added where people will walk on the roof.

Everything about GRP fibreglass roofing → · All flat roofing in Pembrokeshire →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price