Flat RoofingContractors

Flat roof systems

GRP fibreglass roofing across Wrexham

Need a fibreglass roof somewhere in Wrexham? Start with the guide-price tool for a quick figure, then book a free survey. We check the structure, measure the roof, look at falls and upstands, and return a fixed price in writing. Each re-roof comes with a written workmanship guarantee, and the quote states how long it runs.

Finished grey GRP fibreglass flat roof with moulded trims on a single-storey extensionComputer-generated example image
Price per m²
£69–£129
Typical life
20–40 years
Manufacturer guarantees
20–25 year material warranties on specified systems
Typical garage roof
£1,650–£3,000

Wrexham at a glance

Largest towns
Wrexham, Rhosllannerchrugog, Brymbo
Postcode areas
LL
Building control
Wrexham County Borough Council
Neighbouring areas
Flintshire · Denbighshire · Conwy · Gwynedd
Guide price region
Wales (−8% on West Midlands rates)

How much does a GRP fibreglass roof cost in Wrexham?

Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Extension (20 m²), GRP, new deck + insulation£2,750–£4,950
Dormer (8 m²), GRP, scaffold£1,300–£2,450
Single garage (18 m²), GRP fibreglass£1,650–£3,000
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500

Which flat roofs are common in Wrexham?

Flat roofs in Wrexham sit on 1930s semis with flat-roofed garages and kitchen extensions, 1960s and 1970s link-detached houses with flat-roofed garages and porches and shops with flat-roofed rear stores below flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in Wales

Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Wrexham the application goes to Wrexham County Borough Council. More on the rules.

Will a new GRP roof need extra insulation to meet building regulations?

If the roof is over a heated room and you are replacing more than half of it, usually yes. In England, Wales and Northern Ireland that counts as renovating a thermal element, and in Scotland the council's building standards service will say whether a building warrant applies.

GRP pairs well with a warm roof because the new deck boards it needs can sit on top of the insulation. The result is thicker, so we check at survey that there is room under door cills and wall flashings, and that the upstands can finish around 150 mm above the new surface. Where approval is needed we arrange it with building control or building standards.

Unheated, detached garages normally sit outside the thermal rules. See the building regulations page for each nation, or the warm vs cold roof guide for why we avoid cold roofs where we can.

Is GRP better than EPDM, felt or a liquid roof?

GRP is the better choice when you want a rigid, walkable finish, a neat look on a visible roof, or crisp moulded details on a complicated shape. It is not automatically better on a plain garage that nobody steps on.

Strengths: hard surface that takes occasional foot traffic; jointless finish with no laps; trims, kerbs and upstands moulded as part of the roof; choice of topcoat colours; small repairs can be laminated in.

Weaknesses: sensitive to weather while laying; rigid, so it can crack where the structure moves; usually needs a new deck; styrene smell during application; skill-dependent, so workmanship matters more than with sheet systems.

For a simple roof, EPDM rubber is often quicker to lay and more forgiving of movement. Torch-on felt is usually cheaper per square metre. A liquid-applied roof can go over a sound existing surface, larger commercial roofs tend to suit single-ply, and older buildings may already have mastic asphalt worth keeping. The EPDM vs GRP vs felt guide compares the three most common choices.

Which towns in Wrexham do we cover?

GRP fibreglass roofing in Wrexham: questions

Which towns in Wrexham do you cover?

All of Wrexham. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a GRP fibreglass roof cost in Wrexham?

£2,750–£4,950 for a 20 m² extension roof in GRP with a new deck and insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which council handles building control for a flat roof in Wrexham?

It depends on where the roof is: in Wrexham that's Wrexham County Borough Council. Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. We confirm which applies at the survey.

Does GRP smell when it is being laid?

Yes, the resin gives off a strong styrene smell while it cures. It usually fades within a day or so, and we advise keeping nearby windows closed while the team works.

Is GRP suitable for a dormer roof?

Yes, GRP is commonly used on dormers because the trims can be moulded neatly and the finish looks tidy from the ground. Scaffold is normally needed, which we include in the quote.

Can you walk on a GRP roof?

Yes, a correctly laid GRP roof takes occasional foot traffic, such as cleaning windows or maintaining plant. For a regular walkway or terrace, an anti-slip topcoat and a suitable specification are needed.

Everything about GRP fibreglass roofing → · All flat roofing in Wrexham →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price