Arbroath at a glance
- Postcode districts
- DD11
- Population
- about 23,640 (GeoNames)
- Council area
- Angus Council
- Building approval
- Angus Council building standards
- Nearest main town
- Dundee, about 16 miles
- Guide price region
- Scotland (−5% on West Midlands rates)
Why choose a liquid-applied roof in Arbroath?
If a flat roof in Arbroath is ageing but still dry, firmly bonded and on a sound deck, a reinforced liquid system can be applied over it. That avoids the cost and mess of a full strip-out, provided the moisture and adhesion checks at survey show the existing roof is fit to build on.
In a town like Arbroath, flat roofs are commonly found on low-rise post-war blocks of flats or shops with flat-roofed rear stores below flats. Scotland averages roughly 1,570 mm of rain a year, with the west far wetter than the east, so drainage, falls and wind uplift are part of every specification we write.
How much does a liquid-applied roof cost in Arbroath?
Guide price in Arbroath: £1,950–£3,100 for a typical 18 m² garage roof in a liquid-applied system, including VAT at Scotland rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), liquid-applied | £1,950–£3,100 |
| Balcony (12 m²), liquid-applied, scaffold | £1,800–£3,100 |
| Single garage (18 m²), EPDM rubber | £1,500–£2,650 |
| Extension (20 m²), EPDM, new deck + insulation | £2,650–£4,650 |
Can a liquid roof go over my existing roof, and what preparation is needed?
Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.
At survey we check for:
- Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
- Deck condition: any sponginess or deflection needs repair first.
- Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
- Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.
Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.
What's included?
- Primer matched to the substrate
- Detailing of upstands, outlets, pipes and corners before the main area
- Survey of the existing roof, including moisture and adhesion checks
- Fleece-reinforced liquid membrane applied to the specified thickness
Building standards in Scotland
In Scotland the building standards technical handbooks (Section 6 for energy) apply, and the council's building standards service decides whether a building warrant is needed. Like-for-like repairs to a roof covering can be exempt; alterations, structural work and new roofs usually need a warrant before work starts. The domestic roof benchmark is 0.12 W/m²K, applied as far as reasonably practicable on an existing roof. More on the rules.
Which nearby areas do we also cover?
Liquid-applied roofing in Arbroath: questions
Do you cover Arbroath?
Yes. Arbroath is part of our Angus coverage, including postcode districts DD11. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building standards for a flat roof in Arbroath?
Where the work needs approval it goes to Angus Council building standards. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a liquid-applied roof cost in Arbroath?
£1,950–£3,100 for a typical 18 m² garage roof in a liquid-applied system, at Scotland guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Does a liquid roof smell when it is applied?
Some systems, particularly PMMA, have a strong odour during application, while many polyurethane and water-based products are milder. We tell you what to expect and plan around windows and vents.
Can liquid roofing be applied in the rain?
No. The surface must be dry, and most systems need a dry window while they cure. Some fast-curing products shorten that window, but the team will not apply onto a damp roof.