- Price per m²
- £93–£144
- Typical life
- 10–25+ years by product
- Manufacturer guarantees
- 10, 15 or 20-year guarantees by named system
- Typical garage roof
- £2,100–£3,350
Bristol at a glance
- Largest towns
- Bristol
- Postcode areas
- BS
- Building control
- Bristol City Council
- Neighbouring areas
- Somerset · Gloucestershire · Wiltshire · Herefordshire
- Guide price region
- South West (+3% on West Midlands rates)
How much does a liquid-applied roof cost in Bristol?
Guide prices including VAT at South West rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), liquid-applied | £2,100–£3,350 |
| Balcony (12 m²), liquid-applied, scaffold | £1,950–£3,350 |
| Single garage (18 m²), EPDM rubber | £1,650–£2,900 |
| Extension (20 m²), EPDM, new deck + insulation | £2,900–£5,050 |
Which flat roofs are common in Bristol?
Flat roofs in Bristol sit on bungalows with flat-roofed side extensions and dormers, low-rise post-war blocks of flats and newer estates where the first extension roofs are now being replaced. The South West averages roughly 1,260 mm of rain a year and many roofs face wind off the Atlantic, so we specify fixings and edge details for wind uplift as well as drainage. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in England
Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Bristol the application goes to Bristol City Council. More on the rules.
When is a liquid roof the best option, and when is it not?
A liquid roof is often the best option for roofs crowded with pipes, vents and upstands, for balconies and walkways, and for overlaying a structurally sound roof that is starting to fail. It is the wrong choice when the deck is rotten, the insulation is wet or the falls are badly wrong.
Advantages: continuous finish with no laps; forms details around pipes and odd shapes easily; cold-applied with no flame; can often go over felt, asphalt or concrete; some systems take foot traffic.
Disadvantages: higher cost per square metre than felt or EPDM; needs dry weather and careful thickness control; only as good as the surface it is bonded to; product quality varies widely across the market.
For a straightforward re-roof on a fresh deck, EPDM or GRP may offer better value. Larger flat areas suit torch-on felt or single-ply. On a sound mastic asphalt roof, a compatible liquid system can sometimes be applied over it. See also our guide to overlay or strip.
Can a liquid roof go over my existing roof, and what preparation is needed?
Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.
At survey we check for:
- Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
- Deck condition: any sponginess or deflection needs repair first.
- Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
- Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.
Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.
Which towns in Bristol do we cover?
Liquid-applied roofing in Bristol: questions
Which towns in Bristol do you cover?
All of Bristol. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a liquid-applied roof cost in Bristol?
£2,100–£3,350 for a typical 18 m² garage roof in a liquid-applied system, at South West guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which postcode areas do you cover in Bristol?
All of Bristol, including the BS postcode areas. Send your full postcode and we'll confirm.
Does a liquid roof smell when it is applied?
Some systems, particularly PMMA, have a strong odour during application, while many polyurethane and water-based products are milder. We tell you what to expect and plan around windows and vents.
What is a fleece-reinforced liquid roof?
It is a liquid membrane with a polyester fleece embedded between coats. The fleece adds strength, helps control thickness and resists cracking where the surface moves slightly.
Can liquid roofing be applied in the rain?
No. The surface must be dry, and most systems need a dry window while they cure. Some fast-curing products shorten that window, but the team will not apply onto a damp roof.
Everything about liquid-applied roofing → · All flat roofing in Bristol →