Liquid-applied roofing across Cheshire

Price per m²

£86–£133

Typical life

10–25+ years by product

Manufacturer guarantees

10, 15 or 20-year guarantees by named system

Typical garage roof

£1,950–£3,100

How much does a liquid-applied roof cost in Cheshire?

Guide prices including VAT at North West rates. The fixed price comes after a free survey for new and replacement roofs.

Which flat roofs are common in Cheshire?

Flat roofs in Cheshire sit on terraced streets with flat-roofed rear kitchens and bathrooms, low-rise post-war blocks of flats and shops with flat-roofed rear stores below flats. The North West is one of England's wetter regions, averaging roughly 1,290 mm of rain a year, so falls, outlets and well-detailed upstands matter more than the membrane colour. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in England

Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Cheshire the application goes to Warrington Borough Council, Cheshire West and Chester Council, Cheshire East Council and 1 other council. More on the rules.

Do building regulations apply if a liquid coating goes over my roof?

They can. In England, Wales and Northern Ireland, re-covering more than half of a roof over a heated room is usually renovation of a thermal element, even when the new membrane goes over the old, so the roof should be insulated towards the renovation standard where feasible; for a Scottish property, the local building standards team will confirm whether a warrant is required.

A minor coating repair to a small area is different from re-covering the whole roof. Where insulation is needed, an overlay is not always practical, because the insulation has to go under a new waterproof layer. In that case we may recommend stripping to the deck, fitting a warm roof and applying the liquid system on top. Where approval applies, we deal with the paperwork; details are on the building regulations page.

Can a liquid roof go over my existing roof, and what preparation is needed?

Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.

At survey we check for:

• Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
• Deck condition: any sponginess or deflection needs repair first.
• Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
• Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.

Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.

Which towns in Cheshire do we cover?

• Warrington
• Chester
• Crewe
• Ellesmere Port
• Widnes
• Macclesfield
• Northwich
• Great Sankey
• Winsford
• Congleton
• Wilmslow
• Sandbach
• Nantwich
• Neston

Everything about liquid-applied roofing → · All flat roofing in Cheshire →