Flat RoofingContractors

Flat roof systems

Liquid-applied roofing in Skegness

Liquid membranes give Skegness property owners a jointless, cold-applied roof without laps or separate flashings. They are especially useful around pipes, rooflights and tight corners where sheet systems need lots of cutting. If the roof below is wet or rotten, we say so and quote for the right fix instead.

Grey liquid waterproofing and reinforcement fleece rolled around a vent pipe on a flat roofComputer-generated example image

Skegness at a glance

Postcode districts
PE25
Population
about 24,876 (GeoNames)
Council area
East Lindsey District Council
Building approval
East Lindsey District Council building control, or a registered building control approver
Guide price region
East Midlands (−2% on West Midlands rates)

Why choose a liquid-applied roof in Skegness?

For businesses and landlords in Skegness, a cold-applied liquid roof means no flame on site and, with some systems, a short cure time. That can make it easier to work around occupied buildings, tenants and opening hours than a system that needs hot works or a long strip-out.

Skegness's flat roofs are mostly on low-rise post-war blocks of flats, with plenty on 1960s and 1970s link-detached houses with flat-roofed garages and porches too. The East Midlands is drier than the west of Britain, so most flat roofs here fail through age, UV and poor detailing at upstands rather than sheer rainfall.

How much does a liquid-applied roof cost in Skegness?

For Skegness we use East Midlands rates: £2,000–£3,200 is the guide for a typical 18 m² garage roof in a liquid-applied system, VAT included. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), liquid-applied£2,000–£3,200
Balcony (12 m²), liquid-applied, scaffold£1,850–£3,200
Single garage (18 m²), EPDM rubber£1,550–£2,750
Extension (20 m²), EPDM, new deck + insulation£2,750–£4,800

Can a liquid roof go over my existing roof, and what preparation is needed?

Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.

At survey we check for:

  • Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
  • Deck condition: any sponginess or deflection needs repair first.
  • Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
  • Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.

Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.

What's included?

  • Survey of the existing roof, including moisture and adhesion checks
  • Top coat with optional anti-slip finish, and guarantee registration where available
  • Surface cleaning, repairs and removal of loose material
  • Detailing of upstands, outlets, pipes and corners before the main area

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Liquid-applied roofing in Skegness: questions

Do you cover Skegness?

Yes. Skegness is part of our Lincolnshire coverage, including postcode districts PE25. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Skegness?

Where the work needs approval it goes to East Lindsey District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a liquid-applied roof cost in Skegness?

£2,000–£3,200 for a typical 18 m² garage roof in a liquid-applied system, at East Midlands guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

What is a fleece-reinforced liquid roof?

It is a liquid membrane with a polyester fleece embedded between coats. The fleece adds strength, helps control thickness and resists cracking where the surface moves slightly.

Is liquid roofing good for balconies?

Often, yes. It forms neatly around railings, door thresholds and drains, and some systems take foot traffic. A new balcony or roof terrace generally needs planning permission, so check before converting a roof.

Other flat roof work in Skegness

Liquid-applied roofing in Skegness: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price