Neath at a glance
- Postcode districts
- SA11
- Population
- about 46,126 (GeoNames)
- Council area
- Neath Port Talbot County Borough Council
- Building approval
- Neath Port Talbot County Borough Council building control, or a registered building control approver
- Nearest main town
- Swansea, about 7 miles
- Guide price region
- Wales (−8% on West Midlands rates)
Why choose a liquid-applied roof in Neath?
For businesses and landlords in Neath, a cold-applied liquid roof means no flame on site and, with some systems, a short cure time. That can make it easier to work around occupied buildings, tenants and opening hours than a system that needs hot works or a long strip-out.
Around Neath, flat roofs are common on shops with flat-roofed rear stores below flats and on low-rise post-war blocks of flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a liquid-applied roof cost in Neath?
At Wales guide rates, a typical 18 m² garage roof in a liquid-applied system comes to £1,900–£3,000 including VAT. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), liquid-applied | £1,900–£3,000 |
| Balcony (12 m²), liquid-applied, scaffold | £1,750–£3,000 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
Can a liquid roof go over my existing roof, and what preparation is needed?
Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.
At survey we check for:
- Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
- Deck condition: any sponginess or deflection needs repair first.
- Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
- Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.
Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.
What's included?
- Fleece-reinforced liquid membrane applied to the specified thickness
- Surface cleaning, repairs and removal of loose material
- Detailing of upstands, outlets, pipes and corners before the main area
- Top coat with optional anti-slip finish, and guarantee registration where available
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Liquid-applied roofing in Neath: questions
Do you cover Neath?
Yes. Neath is part of our Neath Port Talbot coverage, including postcode districts SA11. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Neath?
Where the work needs approval it goes to Neath Port Talbot County Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a liquid-applied roof cost in Neath?
£1,900–£3,000 for a typical 18 m² garage roof in a liquid-applied system, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Does a liquid roof smell when it is applied?
Some systems, particularly PMMA, have a strong odour during application, while many polyurethane and water-based products are milder. We tell you what to expect and plan around windows and vents.
How long does a liquid roof take to cure?
That depends on the product and the weather. Some systems are rain-resistant within an hour or so, others take longer, and full cure can take a day or more in cool weather.