Flat RoofingContractors

Flat roof systems

Liquid-applied roofing in Haslemere

Our liquid roofing service in Haslemere and across Surrey covers overlays of sound roofs, full re-roofs with a new deck and insulation, and repairs to failing details. Every job starts with careful preparation, because a liquid membrane only performs when it is bonded to a clean, dry and stable surface.

Grey liquid waterproofing and reinforcement fleece rolled around a vent pipe on a flat roofComputer-generated example image

Haslemere at a glance

Postcode districts
GU26, GU27
Population
about 17,279 (GeoNames)
Council area
Waverley Borough Council
Building approval
Waverley Borough Council building control, or a registered building control approver
Nearest main town
Woking, about 17 miles
Guide price region
South East (+10% on West Midlands rates)

Why choose a liquid-applied roof in Haslemere?

Choose liquid roofing in Haslemere when the shape of the roof makes sheet materials awkward: curved edges, small dormers with many corners, or a mix of levels joined by short upstands. Each detail is reinforced in the same material as the main area, so the whole roof is continuous.

Haslemere's flat roofs are mostly on low-rise post-war blocks of flats, with plenty on bungalows with flat-roofed side extensions and dormers too. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain.

How much does a liquid-applied roof cost in Haslemere?

Guide price in Haslemere: £2,250–£3,600 for a typical 18 m² garage roof in a liquid-applied system, including VAT at South East rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), liquid-applied£2,250–£3,600
Balcony (12 m²), liquid-applied, scaffold£2,100–£3,600
Single garage (18 m²), EPDM rubber£1,750–£3,100
Extension (20 m²), EPDM, new deck + insulation£3,100–£5,350

Can a liquid roof go over my existing roof, and what preparation is needed?

Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.

At survey we check for:

  • Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
  • Deck condition: any sponginess or deflection needs repair first.
  • Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
  • Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.

Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.

What's included?

  • Detailing of upstands, outlets, pipes and corners before the main area
  • Surface cleaning, repairs and removal of loose material
  • Primer matched to the substrate
  • Top coat with optional anti-slip finish, and guarantee registration where available

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Liquid-applied roofing in Haslemere: questions

Do you cover Haslemere?

Yes. Haslemere is part of our Surrey coverage, including postcode districts GU26, GU27. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Haslemere?

Where the work needs approval it goes to Waverley Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a liquid-applied roof cost in Haslemere?

£2,250–£3,600 for a typical 18 m² garage roof in a liquid-applied system, at South East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can liquid roofing be applied in the rain?

No. The surface must be dry, and most systems need a dry window while they cure. Some fast-curing products shorten that window, but the team will not apply onto a damp roof.

Does a liquid roof smell when it is applied?

Some systems, particularly PMMA, have a strong odour during application, while many polyurethane and water-based products are milder. We tell you what to expect and plan around windows and vents.

Other flat roof work in Haslemere

Liquid-applied roofing in Haslemere: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price