Flat RoofingContractors

Repairs and surveys

Edge trims, outlets and drainage across Ceredigion

Across Ceredigion, ponding on flat roofs is usually caused by shallow falls, a sagging deck or outlets that are blocked or set too high. A patch won't fix that. We explain whether new outlets will help or whether the falls need correcting with firring or tapered insulation as part of a replacement.

Aluminium drip trim discharging into a new black gutter beside a roof outlet on a rubber flat roofComputer-generated example image
Guide price
£110–£320
Repair price
Confirmed once the leak or damage is found
Condition survey report
£140–£280
Coverage
England, Wales, Scotland, NI

Ceredigion at a glance

Largest towns
Aberystwyth
Postcode areas
SY
Building control
Ceredigion County Council
Neighbouring areas
Powys · Carmarthenshire · Neath Port Talbot · Swansea
Guide price region
Wales (−8% on West Midlands rates)

How much does a new roof edge or outlet cost in Ceredigion?

Guide prices including VAT at Wales rates. We confirm the price once we've traced the leak or seen the damage.

JobGuide price inc VAT
Outlet or drainage repair£110–£320
Localised patch repair£140–£460
Upstand or flashing repair£230–£600
Emergency temporary weatherproofing visit£170–£410
Condition survey and leak investigation£140–£280

Which flat roofs are common in Ceredigion?

Flat roofs in Ceredigion sit on newer estates where the first extension roofs are now being replaced, 1960s and 1970s link-detached houses with flat-roofed garages and porches and shops with flat-roofed rear stores below flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in Wales

Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Ceredigion the application goes to Ceredigion County Council. More on the rules.

Why does water sit on my flat roof?

Water sits on a flat roof because it can't drain off fast enough: the falls are too shallow, part of the roof slopes the wrong way, the deck has sagged between joists, or an outlet is blocked or set too high.

Current guidance on flat roof design (BS 6229) means most roofs need to achieve a finished fall of at least 1:80, and roofs are commonly designed with a steeper fall, such as 1:60, so that building tolerances and deck deflection still leave enough slope. Many older roofs were built with less, or have settled over time.

A small amount of water that clears within a day or two of rain is often tolerable. Deeper ponding that lingers adds weight, holds dirt and debris, can shorten the life of some coverings and turns any small defect into a leak. A patch won't fix it, because the problem is the shape of the roof. The fix is to correct the falls, either with firring pieces under a new deck or with tapered insulation in a warm roof, or to add or lower outlets so water has somewhere to go. Our ponding water guide explains this in more detail.

Do flat roofs need overflows?

Roofs that drain to internal outlets or behind parapets should normally have an overflow, so that if an outlet blocks, water spills somewhere visible instead of rising over the upstands and into the building.

An overflow is usually a spout or weir set through the parapet or kerb at a level below the top of the upstands. When water runs from it, that is a sign the main outlet is blocked or overloaded. On a simple roof that drains over a drip trim into an external gutter, the open edge itself does the same job.

We look at where the water goes in heavy rain, how many outlets the roof has for its size, and whether the outlets, hoppers and downpipes are clear and properly connected. Leaf guards on outlets help on roofs near trees, as long as they are cleared regularly.

Which towns in Ceredigion do we cover?

Edge trims, outlets and drainage in Ceredigion: questions

Which towns in Ceredigion do you cover?

All of Ceredigion. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a new roof edge or outlet cost in Ceredigion?

£110–£320 for an outlet or drainage repair, at Wales guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.

Which postcode areas do you cover in Ceredigion?

All of Ceredigion, including the SY postcode areas. Send your full postcode and we'll confirm.

How often should flat roof outlets be cleared?

At least once a year, ideally in autumn after the leaves fall, and more often for roofs under trees. A quick check after heavy storms is also worthwhile.

What's the difference between a drip trim and an edge trim?

An edge trim finishes the edge of the roof and holds the waterproofing down. A drip trim has a profile that throws water clear into the gutter. On many roofs a single trim does both jobs.

Can a flat roof be re-laid with better falls?

Yes, as part of a replacement. Falls are corrected with tapered firring pieces under a new deck or with tapered insulation in a warm roof build-up.

Everything about edge trims, outlets and drainage → · All flat roofing in Ceredigion →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price