Flat RoofingContractors

Repairs and surveys

Edge trims, outlets and drainage across County Fermanagh

We repair and replace flat roof trims, kerbs, outlets, gutters and overflows across County Fermanagh. Many leaks and most cases of ponding start at the perimeter or with poor drainage, so we check how water moves across the roof before recommending a fix. You get a fixed written price before any work starts.

Aluminium drip trim discharging into a new black gutter beside a roof outlet on a rubber flat roofComputer-generated example image
Guide price
£110–£310
Repair price
Confirmed once the leak or damage is found
Condition survey report
£130–£260
Coverage
England, Wales, Scotland, NI

County Fermanagh at a glance

Largest towns
Enniskillen
Postcode areas
BT
Building control
Fermanagh and Omagh District Council
Neighbouring areas
County Tyrone · County Armagh · County Londonderry · County Antrim
Guide price region
Northern Ireland (−12% on West Midlands rates)

How much does a new roof edge or outlet cost in County Fermanagh?

Guide prices including VAT at Northern Ireland rates. We confirm the price once we've traced the leak or seen the damage.

JobGuide price inc VAT
Outlet or drainage repair£110–£310
Localised patch repair£130–£440
Upstand or flashing repair£220–£570
Emergency temporary weatherproofing visit£160–£400
Condition survey and leak investigation£130–£260

Which flat roofs are common in County Fermanagh?

Flat roofs in County Fermanagh sit on bungalows with flat-roofed side extensions and dormers, shops with flat-roofed rear stores below flats and newer estates where the first extension roofs are now being replaced. Northern Ireland averages roughly 1,150 mm of rain a year, spread over many wet days, so a roof that sheds water quickly to clear outlets lasts far longer than one that holds puddles. Approximate 1991–2020 regional averages based on Met Office data.

Building control in Northern Ireland

In Northern Ireland, renovating or replacing a roof over a heated room usually means meeting Technical Booklet F1, and building control should be contacted before work starts. Technical Booklet F1 sets roof insulation at 0.18 W/m²K when a roof over a heated room is renovated or newly built, where feasible. In County Fermanagh the application goes to Fermanagh and Omagh District Council. More on the rules.

Why does water sit on my flat roof?

Water sits on a flat roof because it can't drain off fast enough: the falls are too shallow, part of the roof slopes the wrong way, the deck has sagged between joists, or an outlet is blocked or set too high.

Current guidance on flat roof design (BS 6229) means most roofs need to achieve a finished fall of at least 1:80, and roofs are commonly designed with a steeper fall, such as 1:60, so that building tolerances and deck deflection still leave enough slope. Many older roofs were built with less, or have settled over time.

A small amount of water that clears within a day or two of rain is often tolerable. Deeper ponding that lingers adds weight, holds dirt and debris, can shorten the life of some coverings and turns any small defect into a leak. A patch won't fix it, because the problem is the shape of the roof. The fix is to correct the falls, either with firring pieces under a new deck or with tapered insulation in a warm roof, or to add or lower outlets so water has somewhere to go. Our ponding water guide explains this in more detail.

Do flat roofs need overflows?

Roofs that drain to internal outlets or behind parapets should normally have an overflow, so that if an outlet blocks, water spills somewhere visible instead of rising over the upstands and into the building.

An overflow is usually a spout or weir set through the parapet or kerb at a level below the top of the upstands. When water runs from it, that is a sign the main outlet is blocked or overloaded. On a simple roof that drains over a drip trim into an external gutter, the open edge itself does the same job.

We look at where the water goes in heavy rain, how many outlets the roof has for its size, and whether the outlets, hoppers and downpipes are clear and properly connected. Leaf guards on outlets help on roofs near trees, as long as they are cleared regularly.

Which towns in County Fermanagh do we cover?

Edge trims, outlets and drainage in County Fermanagh: questions

Which towns in County Fermanagh do you cover?

All of County Fermanagh. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a new roof edge or outlet cost in County Fermanagh?

£110–£310 for an outlet or drainage repair, at Northern Ireland guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.

Which postcode areas do you cover in County Fermanagh?

All of County Fermanagh, including the BT postcode areas. Send your full postcode and we'll confirm.

Do new trims need building regulations approval?

Not usually on their own. Approval only becomes a question if the work is part of a larger re-roofing job or alters the structure.

Is some standing water on a flat roof normal?

A thin film that clears within a day or two of rain is common and usually harmless. Deeper water that lingers for days points to poor falls, a sagging deck or a blocked outlet and should be looked at.

What's the difference between a drip trim and an edge trim?

An edge trim finishes the edge of the roof and holds the waterproofing down. A drip trim has a profile that throws water clear into the gutter. On many roofs a single trim does both jobs.

Everything about edge trims, outlets and drainage → · All flat roofing in County Fermanagh →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price