- Guide price
- £110–£320
- Repair price
- Confirmed once the leak or damage is found
- Condition survey report
- £140–£280
- Coverage
- England, Wales, Scotland, NI
Pembrokeshire at a glance
- Largest towns
- Haverfordwest, Milford Haven, Pembroke Dock, Pembroke
- Postcode areas
- SA
- Building control
- Pembrokeshire County Council
- Neighbouring areas
- Carmarthenshire · Swansea · Neath Port Talbot · Bridgend
- Guide price region
- Wales (−8% on West Midlands rates)
How much does a new roof edge or outlet cost in Pembrokeshire?
Guide prices including VAT at Wales rates. We confirm the price once we've traced the leak or seen the damage.
| Job | Guide price inc VAT |
|---|---|
| Outlet or drainage repair | £110–£320 |
| Localised patch repair | £140–£460 |
| Upstand or flashing repair | £230–£600 |
| Emergency temporary weatherproofing visit | £170–£410 |
| Condition survey and leak investigation | £140–£280 |
Which flat roofs are common in Pembrokeshire?
Flat roofs in Pembrokeshire sit on 1930s semis with flat-roofed garages and kitchen extensions, low-rise post-war blocks of flats and terraced streets with flat-roofed rear kitchens and bathrooms. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in Wales
Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Pembrokeshire the application goes to Pembrokeshire County Council. More on the rules.
Why does water sit on my flat roof?
Water sits on a flat roof because it can't drain off fast enough: the falls are too shallow, part of the roof slopes the wrong way, the deck has sagged between joists, or an outlet is blocked or set too high.
Current guidance on flat roof design (BS 6229) means most roofs need to achieve a finished fall of at least 1:80, and roofs are commonly designed with a steeper fall, such as 1:60, so that building tolerances and deck deflection still leave enough slope. Many older roofs were built with less, or have settled over time.
A small amount of water that clears within a day or two of rain is often tolerable. Deeper ponding that lingers adds weight, holds dirt and debris, can shorten the life of some coverings and turns any small defect into a leak. A patch won't fix it, because the problem is the shape of the roof. The fix is to correct the falls, either with firring pieces under a new deck or with tapered insulation in a warm roof, or to add or lower outlets so water has somewhere to go. Our ponding water guide explains this in more detail.
Do flat roofs need overflows?
Roofs that drain to internal outlets or behind parapets should normally have an overflow, so that if an outlet blocks, water spills somewhere visible instead of rising over the upstands and into the building.
An overflow is usually a spout or weir set through the parapet or kerb at a level below the top of the upstands. When water runs from it, that is a sign the main outlet is blocked or overloaded. On a simple roof that drains over a drip trim into an external gutter, the open edge itself does the same job.
We look at where the water goes in heavy rain, how many outlets the roof has for its size, and whether the outlets, hoppers and downpipes are clear and properly connected. Leaf guards on outlets help on roofs near trees, as long as they are cleared regularly.
Which towns in Pembrokeshire do we cover?
Edge trims, outlets and drainage in Pembrokeshire: questions
Which towns in Pembrokeshire do you cover?
All of Pembrokeshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a new roof edge or outlet cost in Pembrokeshire?
£110–£320 for an outlet or drainage repair, at Wales guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.
Which council handles building control for a flat roof in Pembrokeshire?
It depends on where the roof is: in Pembrokeshire that's Pembrokeshire County Council. Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. We confirm which applies at the survey.
Can a flat roof be re-laid with better falls?
Yes, as part of a replacement. Falls are corrected with tapered firring pieces under a new deck or with tapered insulation in a warm roof build-up.
How often should flat roof outlets be cleared?
At least once a year, ideally in autumn after the leaves fall, and more often for roofs under trees. A quick check after heavy storms is also worthwhile.
Why is my fascia rotting under a flat roof?
Usually because water is getting behind a loose or badly lapped trim, or running back under the edge because there is no proper drip. The fascia and deck edge are replaced and new trims are fitted to stop it happening again.
Everything about edge trims, outlets and drainage → · All flat roofing in Pembrokeshire →