- Guide price
- £110–£330
- Repair price
- Confirmed once the leak or damage is found
- Condition survey report
- £140–£290
- Coverage
- England, Wales, Scotland, NI
Perth and Kinross at a glance
- Largest towns
- Perth, Blairgowrie and Rattray, Crieff
- Postcode areas
- PH
- Building standards
- Perth and Kinross Council
- Neighbouring areas
- Dundee City · Fife · Clackmannanshire · Stirling
- Guide price region
- Scotland (−5% on West Midlands rates)
How much does a new roof edge or outlet cost in Perth and Kinross?
Guide prices including VAT at Scotland rates. We confirm the price once we've traced the leak or seen the damage.
| Job | Guide price inc VAT |
|---|---|
| Outlet or drainage repair | £110–£330 |
| Localised patch repair | £140–£480 |
| Upstand or flashing repair | £240–£620 |
| Emergency temporary weatherproofing visit | £170–£430 |
| Condition survey and leak investigation | £140–£290 |
Which flat roofs are common in Perth and Kinross?
Flat roofs in Perth and Kinross sit on bungalows with flat-roofed side extensions and dormers, lock-up garage blocks on estates and 1960s and 1970s link-detached houses with flat-roofed garages and porches. Scotland averages roughly 1,570 mm of rain a year, with the west far wetter than the east, so drainage, falls and wind uplift are part of every specification we write. Approximate 1991–2020 regional averages based on Met Office data.
Building standards in Scotland
In Scotland a building warrant is usually needed for alterations, structural work and new roofs; like-for-like repairs to a covering can be exempt. Section 6 of the technical handbooks sets a domestic roof benchmark of 0.12 W/m²K, applied as far as reasonably practicable on an existing roof. In Perth and Kinross the application goes to Perth and Kinross Council (building standards). More on the rules.
How long do flat roof trims and outlets last?
Properly fixed GRP or aluminium trims and well-installed outlets should last about as long as the waterproofing they are part of. What shortens their life is poor fixing, movement in a rotten deck edge and blockages that are never cleared.
A quick check of outlets and gutters each autumn, and again after storms, prevents most drainage problems. Look for leaves and silt in outlets, gutters pulling away from the fascia, trims that have lifted or split at joints and staining on the wall below the edge. The maintenance guide lists what to check and when. Only check what you can see safely from the ground, a window or a ladder at the edge, and never walk on a roof that isn't designed for it.
Do flat roofs need overflows?
Roofs that drain to internal outlets or behind parapets should normally have an overflow, so that if an outlet blocks, water spills somewhere visible instead of rising over the upstands and into the building.
An overflow is usually a spout or weir set through the parapet or kerb at a level below the top of the upstands. When water runs from it, that is a sign the main outlet is blocked or overloaded. On a simple roof that drains over a drip trim into an external gutter, the open edge itself does the same job.
We look at where the water goes in heavy rain, how many outlets the roof has for its size, and whether the outlets, hoppers and downpipes are clear and properly connected. Leaf guards on outlets help on roofs near trees, as long as they are cleared regularly.
Which towns in Perth and Kinross do we cover?
Edge trims, outlets and drainage in Perth and Kinross: questions
Which towns in Perth and Kinross do you cover?
All of Perth and Kinross. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a new roof edge or outlet cost in Perth and Kinross?
£110–£330 for an outlet or drainage repair, at Scotland guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.
Which postcode areas do you cover in Perth and Kinross?
All of Perth and Kinross, including the PH postcode areas. Send your full postcode and we'll confirm.
Can you add a new outlet to an existing flat roof?
Usually, yes. The outlet is cut in at a low point, connected to a downpipe or gutter, and the waterproofing is dressed into it with compatible materials. Whether it solves ponding depends on whether water can actually reach it.
What's the difference between a drip trim and an edge trim?
An edge trim finishes the edge of the roof and holds the waterproofing down. A drip trim has a profile that throws water clear into the gutter. On many roofs a single trim does both jobs.
Is some standing water on a flat roof normal?
A thin film that clears within a day or two of rain is common and usually harmless. Deeper water that lingers for days points to poor falls, a sagging deck or a blocked outlet and should be looked at.
Everything about edge trims, outlets and drainage → · All flat roofing in Perth and Kinross →