Flat RoofingContractors

Repairs and surveys

Edge trims, outlets and drainage across Staffordshire

We repair and replace flat roof trims, kerbs, outlets, gutters and overflows across Staffordshire. Many leaks and most cases of ponding start at the perimeter or with poor drainage, so we check how water moves across the roof before recommending a fix. You get a fixed written price before any work starts.

Aluminium drip trim discharging into a new black gutter beside a roof outlet on a rubber flat roofComputer-generated example image
Guide price
£120–£350
Repair price
Confirmed once the leak or damage is found
Condition survey report
£150–£300
Coverage
England, Wales, Scotland, NI

Staffordshire at a glance

Largest towns
Stoke-on-Trent, Newcastle-under-Lyme, Burton upon Trent, Cannock
Postcode areas
B, DE, ST, WS
Building control
Stoke-on-Trent City Council, Newcastle-under-Lyme Borough Council, East Staffordshire Borough Council and 6 other councils
Neighbouring areas
West Midlands · Derbyshire · Shropshire · Cheshire
Guide price region
West Midlands (baseline rates)

How much does a new roof edge or outlet cost in Staffordshire?

Guide prices including VAT at West Midlands rates. We confirm the price once we've traced the leak or seen the damage.

JobGuide price inc VAT
Outlet or drainage repair£120–£350
Localised patch repair£150–£500
Upstand or flashing repair£250–£650
Emergency temporary weatherproofing visit£180–£450
Condition survey and leak investigation£150–£300

Which flat roofs are common in Staffordshire?

Flat roofs in Staffordshire sit on shops with flat-roofed rear stores below flats, 1930s semis with flat-roofed garages and kitchen extensions and bungalows with flat-roofed side extensions and dormers. England averages roughly 870 mm of rain a year and the West Midlands sits close to that, so falls and outlets are the difference between a roof that drains and one that ponds. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in England

Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Staffordshire the application goes to Stoke-on-Trent City Council, Newcastle-under-Lyme Borough Council, East Staffordshire Borough Council and 6 other councils. More on the rules.

Why does water sit on my flat roof?

Water sits on a flat roof because it can't drain off fast enough: the falls are too shallow, part of the roof slopes the wrong way, the deck has sagged between joists, or an outlet is blocked or set too high.

Current guidance on flat roof design (BS 6229) means most roofs need to achieve a finished fall of at least 1:80, and roofs are commonly designed with a steeper fall, such as 1:60, so that building tolerances and deck deflection still leave enough slope. Many older roofs were built with less, or have settled over time.

A small amount of water that clears within a day or two of rain is often tolerable. Deeper ponding that lingers adds weight, holds dirt and debris, can shorten the life of some coverings and turns any small defect into a leak. A patch won't fix it, because the problem is the shape of the roof. The fix is to correct the falls, either with firring pieces under a new deck or with tapered insulation in a warm roof, or to add or lower outlets so water has somewhere to go. Our ponding water guide explains this in more detail.

How long do flat roof trims and outlets last?

Properly fixed GRP or aluminium trims and well-installed outlets should last about as long as the waterproofing they are part of. What shortens their life is poor fixing, movement in a rotten deck edge and blockages that are never cleared.

A quick check of outlets and gutters each autumn, and again after storms, prevents most drainage problems. Look for leaves and silt in outlets, gutters pulling away from the fascia, trims that have lifted or split at joints and staining on the wall below the edge. The maintenance guide lists what to check and when. Only check what you can see safely from the ground, a window or a ladder at the edge, and never walk on a roof that isn't designed for it.

Which towns in Staffordshire do we cover?

Edge trims, outlets and drainage in Staffordshire: questions

Which towns in Staffordshire do you cover?

All of Staffordshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a new roof edge or outlet cost in Staffordshire?

£120–£350 for an outlet or drainage repair, at West Midlands guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.

Which postcode areas do you cover in Staffordshire?

All of Staffordshire, including the B, DE, ST, WS postcode areas. Send your full postcode and we'll confirm.

Do new trims need building regulations approval?

Not usually on their own. Approval only becomes a question if the work is part of a larger re-roofing job or alters the structure.

Can a flat roof be re-laid with better falls?

Yes, as part of a replacement. Falls are corrected with tapered firring pieces under a new deck or with tapered insulation in a warm roof build-up.

Can you add a new outlet to an existing flat roof?

Usually, yes. The outlet is cut in at a low point, connected to a downpipe or gutter, and the waterproofing is dressed into it with compatible materials. Whether it solves ponding depends on whether water can actually reach it.

Everything about edge trims, outlets and drainage → · All flat roofing in Staffordshire →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price