Hedge End at a glance
- Postcode districts
- SO30
- Population
- about 17,978 (GeoNames)
- Council area
- Eastleigh Borough Council
- Building approval
- Eastleigh Borough Council building control, or a registered building control approver
- Nearest main town
- Southampton, about 5 miles
- Guide price region
- South East (+10% on West Midlands rates)
Why choose single-ply roofing in Hedge End?
If a flat roof in Hedge End has poor falls and ponding, a single-ply re-roof with tapered insulation can correct both problems at once. The tapered boards build the fall into the insulation, and the membrane is laid over the top, with outlets set at the new low points.
In and around Hedge End, flat roofs are typically found on terraced streets with flat-roofed rear kitchens and bathrooms, and on bungalows with flat-roofed side extensions and dormers. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain.
How much does a single-ply roof cost in Hedge End?
For Hedge End we use South East rates: £14,550–£23,950 is the guide for a 100 m² commercial roof in single-ply with insulation, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Commercial roof (100 m²), single-ply + insulation | £14,550–£23,950 |
| Single garage (18 m²), single-ply | £2,250–£3,650 |
| Single garage (18 m²), EPDM rubber | £1,750–£3,100 |
| Extension (20 m²), EPDM, new deck + insulation | £3,100–£5,350 |
Should a single-ply roof be mechanically fixed or adhered, and how are the seams welded?
Most commercial single-ply roofs are mechanically fixed, while adhered systems suit decks that cannot take fixings or roofs where a smooth finish is wanted. The choice depends on the deck, the wind exposure of the site and the manufacturer's specification.
| Method | How it works | Typical use |
|---|---|---|
| Mechanically fixed | Fasteners and plates hold the membrane through the insulation into the deck, hidden under the lap of the next sheet | Metal, timber and concrete decks on commercial roofs |
| Adhered | Membrane bonded to the insulation or deck with adhesive | Domestic roofs, roofs where fixings are unsuitable |
| Ballasted | Loose-laid and held down by paving, gravel or a green roof | Inverted roofs, terraces, green roofs |
Fixing patterns are worked out for the site, with more fasteners at corners and perimeters, where wind uplift is strongest.
Seams are welded by hot-air machines and hand tools that melt the overlapping edges so they fuse. Each seam is then probed along its length to find any gaps, and test welds are made at the start of the day to set the machine for the weather. On commercial jobs we also check that walkways protect the membrane around plant.
What's included?
- Welded details at upstands, outlets, rooflight kerbs and edge trims
- Vapour control layer and warm-roof or tapered insulation as specified
- Edge protection on every job and walkway protection around plant
- Hot-air welded seams, each probed along its full length
Building regulations in England
Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.
Which nearby areas do we also cover?
Single-ply membrane roofing in Hedge End: questions
Do you cover Hedge End?
Yes. Hedge End is part of our Hampshire coverage, including postcode districts SO30. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Hedge End?
Where the work needs approval it goes to Eastleigh Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a single-ply roof cost in Hedge End?
£14,550–£23,950 for a 100 m² commercial roof in single-ply with insulation, at South East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
What is the difference between PVC and TPO roofing?
Both are thermoplastic single-ply membranes welded with hot air. PVC contains plasticisers and usually needs separating from bitumen, while TPO and FPO are polyolefin-based; the right one depends on the roof and the system specified.
Can single-ply roofing be laid over an existing roof?
Sometimes, if the existing roof and deck are dry and sound, often with a separation layer or new insulation on top. Wet insulation or a damaged deck means stripping first.