Flat RoofingContractors

Flat roof systems

Single-ply membrane roofing in Evesham

Planning a single-ply roof in Evesham? Use the guide-price tool for a starting figure, then book a free survey. We measure up, check the deck, falls, rooflights and plant, and return a fixed written price. Every re-roof carries our written workmanship guarantee, with manufacturer guarantees registered where the system allows.

Light grey single-ply membrane roof with welded seams, outlets and plant on a commercial buildingComputer-generated example image

Evesham at a glance

Postcode districts
WR11
Population
about 27,684 (GeoNames)
Council area
Wychavon District Council
Building approval
Wychavon District Council building control, or a registered building control approver
Nearest main town
Worcester, about 13 miles
Guide price region
West Midlands (baseline rates)

Why choose single-ply roofing in Evesham?

Single-ply also works on an extension or garage in Evesham if you want a light, clean finish in a pale colour. On small roofs it is usually adhered, and while it can cost more than EPDM, it gives the same welded seams and details found on commercial roofs.

In a town like Evesham, flat roofs are commonly found on newer estates where the first extension roofs are now being replaced or shops with flat-roofed rear stores below flats. England averages roughly 870 mm of rain a year and the West Midlands sits close to that, so falls and outlets are the difference between a roof that drains and one that ponds.

How much does a single-ply roof cost in Evesham?

Guide price in Evesham: £13,250–£21,800 for a 100 m² commercial roof in single-ply with insulation, including VAT at West Midlands rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Commercial roof (100 m²), single-ply + insulation£13,250–£21,800
Single garage (18 m²), single-ply£2,050–£3,350
Single garage (18 m²), EPDM rubber£1,600–£2,800
Extension (20 m²), EPDM, new deck + insulation£2,800–£4,900

What insulation and approvals does a single-ply re-roof need?

On a heated building, a full single-ply re-roof usually triggers the thermal-element rules, so insulation should be brought towards the renovation standard where feasible. In England that is 0.18 W/m²K for non-domestic and 0.16 W/m²K for domestic roofs, with Wales and Northern Ireland setting their own figures; Scottish roofs follow Section 6 of the building standards, and the council confirms whether a building warrant is required.

Single-ply suits a warm roof well, and tapered insulation can correct poor falls at the same time. A thicker build-up raises the roof, so we check upstand heights, door thresholds and rooflight kerbs at survey. Near boundaries, the external fire classification of the tested build-up can matter. We handle building control or building standards where needed; see the building regulations page.

What's included?

  • Strip-out or preparation of the existing roof, with waste removed
  • PVC, TPO or FPO membrane, mechanically fixed, adhered or ballasted
  • Hot-air welded seams, each probed along its full length
  • Welded details at upstands, outlets, rooflight kerbs and edge trims

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Single-ply membrane roofing in Evesham: questions

Do you cover Evesham?

Yes. Evesham is part of our Worcestershire coverage, including postcode districts WR11. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Evesham?

Where the work needs approval it goes to Wychavon District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a single-ply roof cost in Evesham?

£13,250–£21,800 for a 100 m² commercial roof in single-ply with insulation, at West Midlands guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

How long does a commercial single-ply roof take?

A roof of around 100 m² typically takes several days, depending on strip-out, insulation, details and weather. Work is phased so the building stays weathertight and occupied areas are protected.

Can single-ply be used on a house?

Yes. It can be used on garages, extensions and dormers, usually adhered rather than mechanically fixed. On small domestic roofs, though, EPDM or GRP is often more economical.

Other flat roof work in Evesham

Single-ply membrane roofing in Evesham: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price