Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Peterhead

Replacing an old felt roof in Peterhead? Modern torch-on systems are far tougher than the felt many people remember. We strip the existing covering, repair the deck, add warm-roof insulation where needed and lay new membranes with staggered laps. Guide prices are online, and the fixed price comes after our free survey.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Peterhead at a glance

Postcode districts
AB42
Population
about 19,060 (GeoNames)
Council area
Aberdeenshire Council
Building approval
Aberdeenshire Council building standards
Guide price region
Scotland (−5% on West Midlands rates)

Why choose torch-on felt roofing in Peterhead?

Torch-on felt suits property owners in Peterhead who want a dependable, layered roof without paying the top price per square metre. With two or three bonded layers, a single small defect in one sheet need not lead to a leak, which is a real advantage on larger roofs that are hard to inspect often.

In a town like Peterhead, flat roofs are commonly found on 1930s semis with flat-roofed garages and kitchen extensions or lock-up garage blocks on estates. Scotland averages roughly 1,570 mm of rain a year, with the west far wetter than the east, so drainage, falls and wind uplift are part of every specification we write.

How much does a torch-on felt roof cost in Peterhead?

At Scotland guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,450–£2,500 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,450–£2,500
Extension (20 m²), felt, new deck + insulation£2,550–£4,450
Block of flats (150 m²), felt + insulation + scaffold£14,750–£25,850
Single garage (18 m²), EPDM rubber£1,500–£2,650
Extension (20 m²), EPDM, new deck + insulation£2,650–£4,650

Is torch-on roofing safe, and what is the difference between two- and three-layer systems?

Yes, torch-on is safe when hot works are properly controlled, because most roof fires linked to torching start at hidden timber or debris near edges and upstands, not on the open roof. Our teams follow a hot-works routine on every job:

  • check eaves, fascias, soffits and wall cavities for timber, nests and debris before lighting a torch;
  • use a cold-applied or self-adhesive membrane, rather than a flame, at edges, against combustible materials and in tight details;
  • keep fire extinguishers on the roof and the gas bottles secured and away from the work;
  • stop torching well before the team leaves, then carry out a fire watch so smouldering is spotted while people are still on site.

As for layers, a two-layer system (underlay plus cap sheet) is common on domestic roofs such as garages and extensions. A three-layer system adds an intermediate sheet, giving more thickness and redundancy, and is often specified on larger, commercial and multi-occupied roofs. The right choice depends on the size and use of the roof and the system's requirements, so we set it out in the quote.

Near a boundary, the external fire performance of the tested build-up, such as a BROOF(t4) classification, can also matter, and we check it where it applies.

What's included?

  • Hot-works checks and fire watch on every torch-on job
  • Strip-off of the existing roof covering and removal of waste
  • Deck inspection with replacement of damaged boards
  • Mineral-finished cap sheet, upstands, outlets and edge trims

Building standards in Scotland

In Scotland the building standards technical handbooks (Section 6 for energy) apply, and the council's building standards service decides whether a building warrant is needed. Like-for-like repairs to a roof covering can be exempt; alterations, structural work and new roofs usually need a warrant before work starts. The domestic roof benchmark is 0.12 W/m²K, applied as far as reasonably practicable on an existing roof. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Peterhead: questions

Do you cover Peterhead?

Yes. Peterhead is part of our Aberdeenshire coverage, including postcode districts AB42. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building standards for a flat roof in Peterhead?

Where the work needs approval it goes to Aberdeenshire Council building standards. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Peterhead?

£1,450–£2,500 for a typical 18 m² garage roof in torch-on felt, at Scotland guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Is torch-on suitable for a block of flats?

Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

Other flat roof work in Peterhead

Torch-on felt roofing in Peterhead: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price