Flat RoofingContractors

Flat roof systems

Torch-on felt roofing across Conwy

In Conwy, torch-on felt is one of the most economical ways to replace a flat roof properly. We fit two-layer systems on garages and extensions and three-layer systems on larger and multi-occupied roofs. The guide figures shown here are adjusted for the region, and a survey of the deck, falls and access sets your fixed price.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image
Price per m²
£55–£97
Typical life
15–25 years
Manufacturer guarantees
10–20 year material guarantees on specified systems
Typical garage roof
£1,400–£2,400

Conwy at a glance

Largest towns
Colwyn Bay, Llandudno, Abergele
Postcode areas
LL
Building control
Conwy County Borough Council
Neighbouring areas
Denbighshire · Gwynedd · Flintshire · Wrexham
Guide price region
Wales (−8% on West Midlands rates)

How much does a torch-on felt roof cost in Conwy?

Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,400–£2,400
Extension (20 m²), felt, new deck + insulation£2,500–£4,300
Block of flats (150 m²), felt + insulation + scaffold£14,300–£25,000
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500

Which flat roofs are common in Conwy?

Flat roofs in Conwy sit on lock-up garage blocks on estates, 1930s semis with flat-roofed garages and kitchen extensions and shops with flat-roofed rear stores below flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in Wales

Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Conwy the application goes to Conwy County Borough Council. More on the rules.

Should I choose torch-on felt or a different flat roof system?

Choose torch-on felt when you want a proven, layered system at a sensible price, particularly on larger roofs, blocks of flats and commercial buildings where several layers give useful redundancy. It is a weaker choice where hot works are hard to manage safely.

For: generally lower cost per square metre; two or three layers, so a single defect in one layer need not cause a leak; tough mineral finish; long track record and a British Standard code of practice; repairs can be made with compatible materials.

Against: needs a naked flame unless a cold-applied or self-adhesive alternative is used; shorter typical life than EPDM or GRP; the finish is functional rather than decorative; more laps to detail than a single sheet.

On small domestic roofs near timber, EPDM avoids the torch entirely. GRP gives a harder, neater surface. For an overlay, a liquid-applied system is often simpler. Large commercial roofs may suit single-ply, and older buildings may suit mastic asphalt. See our comparison guide.

How long does a torch-on felt roof last, and what is the guarantee?

A modern torch-on roof typically lasts 15 to 25 years, and high-performance systems with better membranes can last longer. That is a big step up from older felt roofs, which were often single-layer, unreinforced or poorly bonded.

What shortens the life of a felt roof is usually visible: mineral chippings worn away so the bitumen is exposed to sunlight, blisters where moisture was trapped, split laps, and upstands that have slumped or pulled away from the wall. Ponding speeds all of this up.

Manufacturer material guarantees are available on many specified torch-on systems; they often depend on a particular build-up and registration, which we handle where the system allows. Every re-roof also comes with our written workmanship guarantee, the length of which is stated in the quote, and insurance-backed options can be discussed. Our flat roof lifespan guide compares felt with the other systems.

Which towns in Conwy do we cover?

Torch-on felt roofing in Conwy: questions

Which towns in Conwy do you cover?

All of Conwy. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a torch-on felt roof cost in Conwy?

£1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which postcode areas do you cover in Conwy?

All of Conwy, including the LL postcode areas. Send your full postcode and we'll confirm.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

How long does it take to lay a torch-on felt roof?

A garage roof typically takes one to two days and an insulated extension two to three. Larger roofs and blocks are phased over longer, with each area made weathertight before the team leaves.

Why does my felt roof have blisters?

Blisters usually form when moisture or air trapped beneath the felt expands in the sun. A few small, intact blisters may be monitored, but widespread or split blisters point to a repair or replacement.

Everything about torch-on felt roofing → · All flat roofing in Conwy →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price