Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Redruth

For blocks of flats, shops and houses in Redruth, torch-on felt remains a practical way to re-roof at a sensible cost. Each job follows the same pattern: survey, written quote, strip and lay, then a fire watch and a walk-round with you before we hand over the written workmanship guarantee.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Redruth at a glance

Postcode districts
TR15, TR16
Population
about 42,690 (GeoNames)
Council area
Cornwall Council
Building approval
Cornwall Council building control, or a registered building control approver
Guide price region
South West (+3% on West Midlands rates)

Why choose torch-on felt roofing in Redruth?

For a commercial roof in Redruth, such as a shop, surgery or club, torch-on felt offers a hard-wearing mineral finish that takes occasional maintenance traffic. Phased work keeps part of the building weathertight while the rest is re-roofed, so the business can usually keep trading.

In a town like Redruth, flat roofs are commonly found on lock-up garage blocks on estates or shops with flat-roofed rear stores below flats. The South West averages roughly 1,260 mm of rain a year and many roofs face wind off the Atlantic, so we specify fixings and edge details for wind uplift as well as drainage.

How much does a torch-on felt roof cost in Redruth?

For Redruth we use South West rates: £1,550–£2,700 is the guide for a typical 18 m² garage roof in torch-on felt, VAT included. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,550–£2,700
Extension (20 m²), felt, new deck + insulation£2,800–£4,850
Block of flats (150 m²), felt + insulation + scaffold£16,000–£28,000
Single garage (18 m²), EPDM rubber£1,650–£2,900
Extension (20 m²), EPDM, new deck + insulation£2,900–£5,050

Is torch-on roofing safe, and what is the difference between two- and three-layer systems?

Yes, torch-on is safe when hot works are properly controlled, because most roof fires linked to torching start at hidden timber or debris near edges and upstands, not on the open roof. Our teams follow a hot-works routine on every job:

  • check eaves, fascias, soffits and wall cavities for timber, nests and debris before lighting a torch;
  • use a cold-applied or self-adhesive membrane, rather than a flame, at edges, against combustible materials and in tight details;
  • keep fire extinguishers on the roof and the gas bottles secured and away from the work;
  • stop torching well before the team leaves, then carry out a fire watch so smouldering is spotted while people are still on site.

As for layers, a two-layer system (underlay plus cap sheet) is common on domestic roofs such as garages and extensions. A three-layer system adds an intermediate sheet, giving more thickness and redundancy, and is often specified on larger, commercial and multi-occupied roofs. The right choice depends on the size and use of the roof and the system's requirements, so we set it out in the quote.

Near a boundary, the external fire performance of the tested build-up, such as a BROOF(t4) classification, can also matter, and we check it where it applies.

What's included?

  • Two- or three-layer reinforced bitumen membrane with staggered laps
  • Deck inspection with replacement of damaged boards
  • Mineral-finished cap sheet, upstands, outlets and edge trims
  • Hot-works checks and fire watch on every torch-on job

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Redruth: questions

Do you cover Redruth?

Yes. Redruth is part of our Cornwall coverage, including postcode districts TR15, TR16. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Redruth?

Where the work needs approval it goes to Cornwall Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Redruth?

£1,550–£2,700 for a typical 18 m² garage roof in torch-on felt, at South West guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Why does my felt roof have blisters?

Blisters usually form when moisture or air trapped beneath the felt expands in the sun. A few small, intact blisters may be monitored, but widespread or split blisters point to a repair or replacement.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

Other flat roof work in Redruth

Torch-on felt roofing in Redruth: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price