Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Seaham

Torch-on felt in Seaham is a layered roof: an underlay, sometimes an intermediate sheet, and a mineral-faced cap sheet, each heat-bonded to the one below. It is generally the most economical of the main systems and suits garages, extensions and larger roofs on blocks and shops alike.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Seaham at a glance

Postcode districts
SR7
Population
about 22,373 (GeoNames)
Council area
Durham County Council
Building approval
Durham County Council building control, or a registered building control approver
Nearest main town
Sunderland, about 5 miles
Guide price region
North East (−7% on West Midlands rates)

Why choose torch-on felt roofing in Seaham?

Torch-on felt suits property owners in Seaham who want a dependable, layered roof without paying the top price per square metre. With two or three bonded layers, a single small defect in one sheet need not lead to a leak, which is a real advantage on larger roofs that are hard to inspect often.

Around Seaham, flat roofs are common on 1930s semis with flat-roofed garages and kitchen extensions and on newer estates where the first extension roofs are now being replaced. England averages roughly 870 mm of rain a year; the North East is drier than the west but cold and windy near the coast, so wind uplift and freeze-thaw are in the specification.

How much does a torch-on felt roof cost in Seaham?

Guide price in Seaham: £1,400–£2,450 for a typical 18 m² garage roof in torch-on felt, including VAT at North East rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,400–£2,450
Extension (20 m²), felt, new deck + insulation£2,500–£4,350
Block of flats (150 m²), felt + insulation + scaffold£14,450–£25,300
Single garage (18 m²), EPDM rubber£1,500–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,550

Does replacing a felt roof mean upgrading the insulation?

Usually, yes, when the roof is over a heated space and more than half of it is being re-covered. In England, Wales and Northern Ireland that is renovation of a thermal element, which should be brought towards the renovation U-value where feasible; a Scottish project goes through the council's building standards service, which confirms whether a warrant applies.

A felt replacement is a good point to switch to a warm roof, with insulation laid above the deck under the new membranes. On larger roofs, tapered insulation can also correct poor falls that have caused ponding, which a patch repair cannot fix. Raising the roof level affects upstands and door thresholds, so we check heights at survey. Any approval is arranged by us as part of the job, and the building regulations page sets out the rules by nation.

What's included?

  • Strip-off of the existing roof covering and removal of waste
  • Vapour control layer and warm-roof insulation where needed
  • Mineral-finished cap sheet, upstands, outlets and edge trims
  • Deck inspection with replacement of damaged boards

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Seaham: questions

Do you cover Seaham?

Yes. Seaham is part of our County Durham coverage, including postcode districts SR7. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Seaham?

Where the work needs approval it goes to Durham County Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Seaham?

£1,400–£2,450 for a typical 18 m² garage roof in torch-on felt, at North East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

How long does it take to lay a torch-on felt roof?

A garage roof typically takes one to two days and an insulated extension two to three. Larger roofs and blocks are phased over longer, with each area made weathertight before the team leaves.

Why does my felt roof have blisters?

Blisters usually form when moisture or air trapped beneath the felt expands in the sun. A few small, intact blisters may be monitored, but widespread or split blisters point to a repair or replacement.

Other flat roof work in Seaham

Torch-on felt roofing in Seaham: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price