Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Frinton-on-Sea

Torch-on felt in Frinton-on-Sea is a layered roof: an underlay, sometimes an intermediate sheet, and a mineral-faced cap sheet, each heat-bonded to the one below. It is generally the most economical of the main systems and suits garages, extensions and larger roofs on blocks and shops alike.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Frinton-on-Sea at a glance

Postcode districts
CO13
Population
about 16,941 (GeoNames)
Council area
Tendring District Council
Building approval
Tendring District Council building control, or a registered building control approver
Nearest main town
Colchester, about 15 miles
Guide price region
East of England (+5% on West Midlands rates)

Why choose torch-on felt roofing in Frinton-on-Sea?

On larger roofs in Frinton-on-Sea with poor falls, torch-on felt pairs well with tapered insulation, which builds the fall into the insulation boards. That deals with ponding properly while adding insulation, rather than patching the low spots and waiting for the next leak.

In and around Frinton-on-Sea, flat roofs are typically found on 1960s and 1970s link-detached houses with flat-roofed garages and porches, and on newer estates where the first extension roofs are now being replaced. The East of England is the driest part of Britain, with parts of the Anglian region around 630 mm a year, so summer heat and UV, not rainfall, do most of the ageing on a felt roof.

How much does a torch-on felt roof cost in Frinton-on-Sea?

At East of England guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,600–£2,750 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,600–£2,750
Extension (20 m²), felt, new deck + insulation£2,850–£4,900
Block of flats (150 m²), felt + insulation + scaffold£16,350–£28,550
Single garage (18 m²), EPDM rubber£1,700–£2,950
Extension (20 m²), EPDM, new deck + insulation£2,950–£5,150

Should I choose torch-on felt or a different flat roof system?

Choose torch-on felt when you want a proven, layered system at a sensible price, particularly on larger roofs, blocks of flats and commercial buildings where several layers give useful redundancy. It is a weaker choice where hot works are hard to manage safely.

For: generally lower cost per square metre; two or three layers, so a single defect in one layer need not cause a leak; tough mineral finish; long track record and a British Standard code of practice; repairs can be made with compatible materials.

Against: needs a naked flame unless a cold-applied or self-adhesive alternative is used; shorter typical life than EPDM or GRP; the finish is functional rather than decorative; more laps to detail than a single sheet.

On small domestic roofs near timber, EPDM avoids the torch entirely. GRP gives a harder, neater surface. For an overlay, a liquid-applied system is often simpler. Large commercial roofs may suit single-ply, and older buildings may suit mastic asphalt. See our comparison guide.

What's included?

  • Deck inspection with replacement of damaged boards
  • Hot-works checks and fire watch on every torch-on job
  • Vapour control layer and warm-roof insulation where needed
  • Two- or three-layer reinforced bitumen membrane with staggered laps

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Frinton-on-Sea: questions

Do you cover Frinton-on-Sea?

Yes. Frinton-on-Sea is part of our Essex coverage, including postcode districts CO13. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Frinton-on-Sea?

Where the work needs approval it goes to Tendring District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Frinton-on-Sea?

£1,600–£2,750 for a typical 18 m² garage roof in torch-on felt, at East of England guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can torch-on felt go over an existing felt roof?

Sometimes, if the old roof is dry, well bonded and the deck is sound. Often stripping is better, because overlaying can trap moisture and hide rot; our guide to overlay or strip explains how we decide.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

Other flat roof work in Frinton-on-Sea

Torch-on felt roofing in Frinton-on-Sea: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price