Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Potters Bar

For blocks of flats, shops and houses in Potters Bar, torch-on felt remains a practical way to re-roof at a sensible cost. Each job follows the same pattern: survey, written quote, strip and lay, then a fire watch and a walk-round with you before we hand over the written workmanship guarantee.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Potters Bar at a glance

Postcode districts
EN6
Population
about 22,639 (GeoNames)
Council area
Hertsmere Borough Council
Building approval
Hertsmere Borough Council building control, or a registered building control approver
Nearest main town
St Albans, about 8 miles
Guide price region
East of England (+5% on West Midlands rates)

Why choose torch-on felt roofing in Potters Bar?

On larger roofs in Potters Bar with poor falls, torch-on felt pairs well with tapered insulation, which builds the fall into the insulation boards. That deals with ponding properly while adding insulation, rather than patching the low spots and waiting for the next leak.

In and around Potters Bar, flat roofs are typically found on 1930s semis with flat-roofed garages and kitchen extensions, and on bungalows with flat-roofed side extensions and dormers. The East of England is the driest part of Britain, with parts of the Anglian region around 630 mm a year, so summer heat and UV, not rainfall, do most of the ageing on a felt roof.

How much does a torch-on felt roof cost in Potters Bar?

Guide price in Potters Bar: £1,600–£2,750 for a typical 18 m² garage roof in torch-on felt, including VAT at East of England rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,600–£2,750
Extension (20 m²), felt, new deck + insulation£2,850–£4,900
Block of flats (150 m²), felt + insulation + scaffold£16,350–£28,550
Single garage (18 m²), EPDM rubber£1,700–£2,950
Extension (20 m²), EPDM, new deck + insulation£2,950–£5,150

Does replacing a felt roof mean upgrading the insulation?

Usually, yes, when the roof is over a heated space and more than half of it is being re-covered. In England, Wales and Northern Ireland that is renovation of a thermal element, which should be brought towards the renovation U-value where feasible; a Scottish project goes through the council's building standards service, which confirms whether a warrant applies.

A felt replacement is a good point to switch to a warm roof, with insulation laid above the deck under the new membranes. On larger roofs, tapered insulation can also correct poor falls that have caused ponding, which a patch repair cannot fix. Raising the roof level affects upstands and door thresholds, so we check heights at survey. Any approval is arranged by us as part of the job, and the building regulations page sets out the rules by nation.

What's included?

  • Hot-works checks and fire watch on every torch-on job
  • Strip-off of the existing roof covering and removal of waste
  • Vapour control layer and warm-roof insulation where needed
  • Mineral-finished cap sheet, upstands, outlets and edge trims

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Potters Bar: questions

Do you cover Potters Bar?

Yes. Potters Bar is part of our Hertfordshire coverage, including postcode districts EN6. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Potters Bar?

Where the work needs approval it goes to Hertsmere Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Potters Bar?

£1,600–£2,750 for a typical 18 m² garage roof in torch-on felt, at East of England guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can torch-on felt be laid in wet weather?

Not in rain or on a wet deck, because moisture trapped under the membrane causes blisters. Light cold weather is usually workable, but we will postpone rather than lay on a damp surface.

Why does my felt roof have blisters?

Blisters usually form when moisture or air trapped beneath the felt expands in the sun. A few small, intact blisters may be monitored, but widespread or split blisters point to a repair or replacement.

Other flat roof work in Potters Bar

Torch-on felt roofing in Potters Bar: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price