Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Ware

We lay torch-on felt roofs in Ware for homeowners, landlords and commercial owners, using modern reinforced bitumen membranes in two or three bonded layers. A free survey comes first, then a fixed written quote. The work is done by vetted roofing teams working under S&K, with a fire watch after every torching session.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Ware at a glance

Postcode districts
SG12
Population
about 17,576 (GeoNames)
Council area
East Hertfordshire District Council
Building approval
East Hertfordshire District Council building control, or a registered building control approver
Nearest main town
Harlow, about 6 miles
Guide price region
East of England (+5% on West Midlands rates)

Why choose torch-on felt roofing in Ware?

On larger roofs in Ware with poor falls, torch-on felt pairs well with tapered insulation, which builds the fall into the insulation boards. That deals with ponding properly while adding insulation, rather than patching the low spots and waiting for the next leak.

In and around Ware, flat roofs are typically found on newer estates where the first extension roofs are now being replaced, and on lock-up garage blocks on estates. The East of England is the driest part of Britain, with parts of the Anglian region around 630 mm a year, so summer heat and UV, not rainfall, do most of the ageing on a felt roof.

How much does a torch-on felt roof cost in Ware?

At East of England guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,600–£2,750 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,600–£2,750
Extension (20 m²), felt, new deck + insulation£2,850–£4,900
Block of flats (150 m²), felt + insulation + scaffold£16,350–£28,550
Single garage (18 m²), EPDM rubber£1,700–£2,950
Extension (20 m²), EPDM, new deck + insulation£2,950–£5,150

Does replacing a felt roof mean upgrading the insulation?

Usually, yes, when the roof is over a heated space and more than half of it is being re-covered. In England, Wales and Northern Ireland that is renovation of a thermal element, which should be brought towards the renovation U-value where feasible; a Scottish project goes through the council's building standards service, which confirms whether a warrant applies.

A felt replacement is a good point to switch to a warm roof, with insulation laid above the deck under the new membranes. On larger roofs, tapered insulation can also correct poor falls that have caused ponding, which a patch repair cannot fix. Raising the roof level affects upstands and door thresholds, so we check heights at survey. Any approval is arranged by us as part of the job, and the building regulations page sets out the rules by nation.

What's included?

  • Two- or three-layer reinforced bitumen membrane with staggered laps
  • Hot-works checks and fire watch on every torch-on job
  • Mineral-finished cap sheet, upstands, outlets and edge trims
  • Strip-off of the existing roof covering and removal of waste

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Ware: questions

Do you cover Ware?

Yes. Ware is part of our Hertfordshire coverage, including postcode districts SG12. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Ware?

Where the work needs approval it goes to East Hertfordshire District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Ware?

£1,600–£2,750 for a typical 18 m² garage roof in torch-on felt, at East of England guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Is torch-on suitable for a block of flats?

Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

Other flat roof work in Ware

Torch-on felt roofing in Ware: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price