Briton Ferry at a glance
- Postcode districts
- SA11
- Population
- about 35,179 (GeoNames)
- Council area
- Neath Port Talbot County Borough Council
- Building approval
- Neath Port Talbot County Borough Council building control, or a registered building control approver
- Nearest main town
- Neath, about 2 miles
- Guide price region
- Wales (−8% on West Midlands rates)
Why choose torch-on felt roofing in Briton Ferry?
Torch-on felt is widely specified for blocks of flats and HMOs, in Briton Ferry as elsewhere, because the system is well understood, widely repairable and governed by a British Standard code of practice. Three-layer builds with insulation are common on larger, multi-occupied roofs.
Around Briton Ferry, flat roofs are common on 1960s and 1970s link-detached houses with flat-roofed garages and porches and on lock-up garage blocks on estates. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a torch-on felt roof cost in Briton Ferry?
For Briton Ferry we use Wales rates: £1,400–£2,400 is the guide for a typical 18 m² garage roof in torch-on felt, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), torch-on felt | £1,400–£2,400 |
| Extension (20 m²), felt, new deck + insulation | £2,500–£4,300 |
| Block of flats (150 m²), felt + insulation + scaffold | £14,300–£25,000 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
Does replacing a felt roof mean upgrading the insulation?
Usually, yes, when the roof is over a heated space and more than half of it is being re-covered. In England, Wales and Northern Ireland that is renovation of a thermal element, which should be brought towards the renovation U-value where feasible; a Scottish project goes through the council's building standards service, which confirms whether a warrant applies.
A felt replacement is a good point to switch to a warm roof, with insulation laid above the deck under the new membranes. On larger roofs, tapered insulation can also correct poor falls that have caused ponding, which a patch repair cannot fix. Raising the roof level affects upstands and door thresholds, so we check heights at survey. Any approval is arranged by us as part of the job, and the building regulations page sets out the rules by nation.
What's included?
- Mineral-finished cap sheet, upstands, outlets and edge trims
- Deck inspection with replacement of damaged boards
- Two- or three-layer reinforced bitumen membrane with staggered laps
- Vapour control layer and warm-roof insulation where needed
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Torch-on felt roofing in Briton Ferry: questions
Do you cover Briton Ferry?
Yes. Briton Ferry is part of our Neath Port Talbot coverage, including postcode districts SA11. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Briton Ferry?
Where the work needs approval it goes to Neath Port Talbot County Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a torch-on felt roof cost in Briton Ferry?
£1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
How long does it take to lay a torch-on felt roof?
A garage roof typically takes one to two days and an insulated extension two to three. Larger roofs and blocks are phased over longer, with each area made weathertight before the team leaves.
Is torch-on suitable for a block of flats?
Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.