- Price per m²
- £57–£100
- Typical life
- 15–25 years
- Manufacturer guarantees
- 10–20 year material guarantees on specified systems
- Typical garage roof
- £1,450–£2,500
Perth and Kinross at a glance
- Largest towns
- Perth, Blairgowrie and Rattray, Crieff
- Postcode areas
- PH
- Building standards
- Perth and Kinross Council
- Neighbouring areas
- Dundee City · Fife · Clackmannanshire · Stirling
- Guide price region
- Scotland (−5% on West Midlands rates)
How much does a torch-on felt roof cost in Perth and Kinross?
Guide prices including VAT at Scotland rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), torch-on felt | £1,450–£2,500 |
| Extension (20 m²), felt, new deck + insulation | £2,550–£4,450 |
| Block of flats (150 m²), felt + insulation + scaffold | £14,750–£25,850 |
| Single garage (18 m²), EPDM rubber | £1,500–£2,650 |
| Extension (20 m²), EPDM, new deck + insulation | £2,650–£4,650 |
Which flat roofs are common in Perth and Kinross?
Flat roofs in Perth and Kinross sit on low-rise post-war blocks of flats, terraced streets with flat-roofed rear kitchens and bathrooms and shops with flat-roofed rear stores below flats. Scotland averages roughly 1,570 mm of rain a year, with the west far wetter than the east, so drainage, falls and wind uplift are part of every specification we write. Approximate 1991–2020 regional averages based on Met Office data.
Building standards in Scotland
In Scotland a building warrant is usually needed for alterations, structural work and new roofs; like-for-like repairs to a covering can be exempt. Section 6 of the technical handbooks sets a domestic roof benchmark of 0.12 W/m²K, applied as far as reasonably practicable on an existing roof. In Perth and Kinross the application goes to Perth and Kinross Council (building standards). More on the rules.
How long does a torch-on felt roof last, and what is the guarantee?
A modern torch-on roof typically lasts 15 to 25 years, and high-performance systems with better membranes can last longer. That is a big step up from older felt roofs, which were often single-layer, unreinforced or poorly bonded.
What shortens the life of a felt roof is usually visible: mineral chippings worn away so the bitumen is exposed to sunlight, blisters where moisture was trapped, split laps, and upstands that have slumped or pulled away from the wall. Ponding speeds all of this up.
Manufacturer material guarantees are available on many specified torch-on systems; they often depend on a particular build-up and registration, which we handle where the system allows. Every re-roof also comes with our written workmanship guarantee, the length of which is stated in the quote, and insurance-backed options can be discussed. Our flat roof lifespan guide compares felt with the other systems.
Which towns in Perth and Kinross do we cover?
Torch-on felt roofing in Perth and Kinross: questions
Which towns in Perth and Kinross do you cover?
All of Perth and Kinross. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a torch-on felt roof cost in Perth and Kinross?
£1,450–£2,500 for a typical 18 m² garage roof in torch-on felt, at Scotland guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which council handles building standards for a flat roof in Perth and Kinross?
It depends on where the roof is: in Perth and Kinross that's Perth and Kinross Council. In Scotland a building warrant is usually needed for alterations, structural work and new roofs; like-for-like repairs to a covering can be exempt. We confirm which applies at the survey.
Is torch-on suitable for a block of flats?
Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.
How long does it take to lay a torch-on felt roof?
A garage roof typically takes one to two days and an insulated extension two to three. Larger roofs and blocks are phased over longer, with each area made weathertight before the team leaves.
Can torch-on felt go over an existing felt roof?
Sometimes, if the old roof is dry, well bonded and the deck is sound. Often stripping is better, because overlaying can trap moisture and hide rot; our guide to overlay or strip explains how we decide.
Everything about torch-on felt roofing → · All flat roofing in Perth and Kinross →