Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Tonyrefail

Across Rhondda Cynon Taf, including Tonyrefail, we use torch-on felt on roofs where a proven, multi-layer system makes sense. The surveyor checks the deck, the falls and any timber near the edges before recommending two or three layers, and every detail is set out in your fixed written quote.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Tonyrefail at a glance

Postcode districts
CF39
Population
about 9,317 (GeoNames)
Council area
Rhondda Cynon Taf County Borough Council
Building approval
Rhondda Cynon Taf County Borough Council building control, or a registered building control approver
Nearest main town
Rhondda, about 5 miles
Guide price region
Wales (−8% on West Midlands rates)

Why choose torch-on felt roofing in Tonyrefail?

Torch-on is a good fit in Tonyrefail when the budget matters but quality cannot slip. Modern polyester-reinforced membranes typically last 15 to 25 years, high-performance systems longer, and manufacturer material guarantees are available on many specified systems, registered where the system allows.

Around Tonyrefail, flat roofs are common on 1960s and 1970s link-detached houses with flat-roofed garages and porches and on shops with flat-roofed rear stores below flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.

How much does a torch-on felt roof cost in Tonyrefail?

Guide price in Tonyrefail: £1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,400–£2,400
Extension (20 m²), felt, new deck + insulation£2,500–£4,300
Block of flats (150 m²), felt + insulation + scaffold£14,300–£25,000
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500

Is torch-on roofing safe, and what is the difference between two- and three-layer systems?

Yes, torch-on is safe when hot works are properly controlled, because most roof fires linked to torching start at hidden timber or debris near edges and upstands, not on the open roof. Our teams follow a hot-works routine on every job:

  • check eaves, fascias, soffits and wall cavities for timber, nests and debris before lighting a torch;
  • use a cold-applied or self-adhesive membrane, rather than a flame, at edges, against combustible materials and in tight details;
  • keep fire extinguishers on the roof and the gas bottles secured and away from the work;
  • stop torching well before the team leaves, then carry out a fire watch so smouldering is spotted while people are still on site.

As for layers, a two-layer system (underlay plus cap sheet) is common on domestic roofs such as garages and extensions. A three-layer system adds an intermediate sheet, giving more thickness and redundancy, and is often specified on larger, commercial and multi-occupied roofs. The right choice depends on the size and use of the roof and the system's requirements, so we set it out in the quote.

Near a boundary, the external fire performance of the tested build-up, such as a BROOF(t4) classification, can also matter, and we check it where it applies.

What's included?

  • Vapour control layer and warm-roof insulation where needed
  • Deck inspection with replacement of damaged boards
  • Strip-off of the existing roof covering and removal of waste
  • Two- or three-layer reinforced bitumen membrane with staggered laps

Building regulations in Wales

The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Tonyrefail: questions

Do you cover Tonyrefail?

Yes. Tonyrefail is part of our Rhondda Cynon Taf coverage, including postcode districts CF39. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Tonyrefail?

Where the work needs approval it goes to Rhondda Cynon Taf County Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Tonyrefail?

£1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Is torch-on suitable for a block of flats?

Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.

Why does my felt roof have blisters?

Blisters usually form when moisture or air trapped beneath the felt expands in the sun. A few small, intact blisters may be monitored, but widespread or split blisters point to a repair or replacement.

Other flat roof work in Tonyrefail

Torch-on felt roofing in Tonyrefail: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price