Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Hoyland

Replacing an old felt roof in Hoyland? Modern torch-on systems are far tougher than the felt many people remember. We strip the existing covering, repair the deck, add warm-roof insulation where needed and lay new membranes with staggered laps. Guide prices are online, and the fixed price comes after our free survey.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Hoyland at a glance

Postcode districts
S74
Population
about 15,842 (GeoNames)
Council area
Barnsley Council
Building approval
Barnsley Council building control, or a registered building control approver
Nearest main town
Rotherham, about 6 miles
Guide price region
Yorkshire and the Humber (−5% on West Midlands rates)

Why choose torch-on felt roofing in Hoyland?

Torch-on is a good fit in Hoyland when the budget matters but quality cannot slip. Modern polyester-reinforced membranes typically last 15 to 25 years, high-performance systems longer, and manufacturer material guarantees are available on many specified systems, registered where the system allows.

Hoyland's flat roofs are mostly on newer estates where the first extension roofs are now being replaced, with plenty on low-rise post-war blocks of flats too. England averages roughly 870 mm of rain a year; the Pennine side of Yorkshire is wetter and windier than the east, so we specify for the site rather than the county.

How much does a torch-on felt roof cost in Hoyland?

Guide price in Hoyland: £1,450–£2,500 for a typical 18 m² garage roof in torch-on felt, including VAT at Yorkshire and the Humber rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,450–£2,500
Extension (20 m²), felt, new deck + insulation£2,550–£4,450
Block of flats (150 m²), felt + insulation + scaffold£14,750–£25,850
Single garage (18 m²), EPDM rubber£1,500–£2,650
Extension (20 m²), EPDM, new deck + insulation£2,650–£4,650

Is torch-on roofing safe, and what is the difference between two- and three-layer systems?

Yes, torch-on is safe when hot works are properly controlled, because most roof fires linked to torching start at hidden timber or debris near edges and upstands, not on the open roof. Our teams follow a hot-works routine on every job:

  • check eaves, fascias, soffits and wall cavities for timber, nests and debris before lighting a torch;
  • use a cold-applied or self-adhesive membrane, rather than a flame, at edges, against combustible materials and in tight details;
  • keep fire extinguishers on the roof and the gas bottles secured and away from the work;
  • stop torching well before the team leaves, then carry out a fire watch so smouldering is spotted while people are still on site.

As for layers, a two-layer system (underlay plus cap sheet) is common on domestic roofs such as garages and extensions. A three-layer system adds an intermediate sheet, giving more thickness and redundancy, and is often specified on larger, commercial and multi-occupied roofs. The right choice depends on the size and use of the roof and the system's requirements, so we set it out in the quote.

Near a boundary, the external fire performance of the tested build-up, such as a BROOF(t4) classification, can also matter, and we check it where it applies.

What's included?

  • Hot-works checks and fire watch on every torch-on job
  • Two- or three-layer reinforced bitumen membrane with staggered laps
  • Deck inspection with replacement of damaged boards
  • Vapour control layer and warm-roof insulation where needed

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Hoyland: questions

Do you cover Hoyland?

Yes. Hoyland is part of our South Yorkshire coverage, including postcode districts S74. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Hoyland?

Where the work needs approval it goes to Barnsley Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Hoyland?

£1,450–£2,500 for a typical 18 m² garage roof in torch-on felt, at Yorkshire and the Humber guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Is torch-on suitable for a block of flats?

Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

Other flat roof work in Hoyland

Torch-on felt roofing in Hoyland: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price