Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Burntwood

Torch-on felt in Burntwood is a layered roof: an underlay, sometimes an intermediate sheet, and a mineral-faced cap sheet, each heat-bonded to the one below. It is generally the most economical of the main systems and suits garages, extensions and larger roofs on blocks and shops alike.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Burntwood at a glance

Postcode districts
WS7
Population
about 29,244 (GeoNames)
Council area
Lichfield District Council
Building approval
Lichfield District Council building control, or a registered building control approver
Nearest main town
Cannock, about 4 miles
Guide price region
West Midlands (baseline rates)

Why choose torch-on felt roofing in Burntwood?

On larger roofs in Burntwood with poor falls, torch-on felt pairs well with tapered insulation, which builds the fall into the insulation boards. That deals with ponding properly while adding insulation, rather than patching the low spots and waiting for the next leak.

Burntwood's flat roofs are mostly on newer estates where the first extension roofs are now being replaced, with plenty on shops with flat-roofed rear stores below flats too. England averages roughly 870 mm of rain a year and the West Midlands sits close to that, so falls and outlets are the difference between a roof that drains and one that ponds.

How much does a torch-on felt roof cost in Burntwood?

At West Midlands guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,500–£2,600 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,500–£2,600
Extension (20 m²), felt, new deck + insulation£2,700–£4,700
Block of flats (150 m²), felt + insulation + scaffold£15,550–£27,200
Single garage (18 m²), EPDM rubber£1,600–£2,800
Extension (20 m²), EPDM, new deck + insulation£2,800–£4,900

Does replacing a felt roof mean upgrading the insulation?

Usually, yes, when the roof is over a heated space and more than half of it is being re-covered. In England, Wales and Northern Ireland that is renovation of a thermal element, which should be brought towards the renovation U-value where feasible; a Scottish project goes through the council's building standards service, which confirms whether a warrant applies.

A felt replacement is a good point to switch to a warm roof, with insulation laid above the deck under the new membranes. On larger roofs, tapered insulation can also correct poor falls that have caused ponding, which a patch repair cannot fix. Raising the roof level affects upstands and door thresholds, so we check heights at survey. Any approval is arranged by us as part of the job, and the building regulations page sets out the rules by nation.

What's included?

  • Mineral-finished cap sheet, upstands, outlets and edge trims
  • Deck inspection with replacement of damaged boards
  • Hot-works checks and fire watch on every torch-on job
  • Vapour control layer and warm-roof insulation where needed

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Burntwood: questions

Do you cover Burntwood?

Yes. Burntwood is part of our Staffordshire coverage, including postcode districts WS7. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Burntwood?

Where the work needs approval it goes to Lichfield District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Burntwood?

£1,500–£2,600 for a typical 18 m² garage roof in torch-on felt, at West Midlands guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

Is torch-on suitable for a block of flats?

Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.

Other flat roof work in Burntwood

Torch-on felt roofing in Burntwood: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price