Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Leek

Torch-on felt in Leek is a layered roof: an underlay, sometimes an intermediate sheet, and a mineral-faced cap sheet, each heat-bonded to the one below. It is generally the most economical of the main systems and suits garages, extensions and larger roofs on blocks and shops alike.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Leek at a glance

Postcode districts
ST13
Population
about 19,385 (GeoNames)
Council area
Staffordshire Moorlands District Council
Building approval
Staffordshire Moorlands District Council building control, or a registered building control approver
Nearest main town
Stoke-on-Trent, about 10 miles
Guide price region
West Midlands (baseline rates)

Why choose torch-on felt roofing in Leek?

On larger roofs in Leek with poor falls, torch-on felt pairs well with tapered insulation, which builds the fall into the insulation boards. That deals with ponding properly while adding insulation, rather than patching the low spots and waiting for the next leak.

Around Leek, flat roofs are common on bungalows with flat-roofed side extensions and dormers and on 1930s semis with flat-roofed garages and kitchen extensions. England averages roughly 870 mm of rain a year and the West Midlands sits close to that, so falls and outlets are the difference between a roof that drains and one that ponds.

How much does a torch-on felt roof cost in Leek?

Guide price in Leek: £1,500–£2,600 for a typical 18 m² garage roof in torch-on felt, including VAT at West Midlands rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,500–£2,600
Extension (20 m²), felt, new deck + insulation£2,700–£4,700
Block of flats (150 m²), felt + insulation + scaffold£15,550–£27,200
Single garage (18 m²), EPDM rubber£1,600–£2,800
Extension (20 m²), EPDM, new deck + insulation£2,800–£4,900

Should I choose torch-on felt or a different flat roof system?

Choose torch-on felt when you want a proven, layered system at a sensible price, particularly on larger roofs, blocks of flats and commercial buildings where several layers give useful redundancy. It is a weaker choice where hot works are hard to manage safely.

For: generally lower cost per square metre; two or three layers, so a single defect in one layer need not cause a leak; tough mineral finish; long track record and a British Standard code of practice; repairs can be made with compatible materials.

Against: needs a naked flame unless a cold-applied or self-adhesive alternative is used; shorter typical life than EPDM or GRP; the finish is functional rather than decorative; more laps to detail than a single sheet.

On small domestic roofs near timber, EPDM avoids the torch entirely. GRP gives a harder, neater surface. For an overlay, a liquid-applied system is often simpler. Large commercial roofs may suit single-ply, and older buildings may suit mastic asphalt. See our comparison guide.

What's included?

  • Strip-off of the existing roof covering and removal of waste
  • Mineral-finished cap sheet, upstands, outlets and edge trims
  • Hot-works checks and fire watch on every torch-on job
  • Two- or three-layer reinforced bitumen membrane with staggered laps

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Leek: questions

Do you cover Leek?

Yes. Leek is part of our Staffordshire coverage, including postcode districts ST13. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Leek?

Where the work needs approval it goes to Staffordshire Moorlands District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Leek?

£1,500–£2,600 for a typical 18 m² garage roof in torch-on felt, at West Midlands guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Is torch-on felt better than the old felt roofs?

Yes, considerably. Modern torch-on membranes are polymer-modified and polyester-reinforced, laid in bonded layers, and typically last much longer than the older felt systems they replace.

How long does it take to lay a torch-on felt roof?

A garage roof typically takes one to two days and an insulated extension two to three. Larger roofs and blocks are phased over longer, with each area made weathertight before the team leaves.

Other flat roof work in Leek

Torch-on felt roofing in Leek: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price