Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Bannockburn

Across Stirling, including Bannockburn, we use torch-on felt on roofs where a proven, multi-layer system makes sense. The surveyor checks the deck, the falls and any timber near the edges before recommending two or three layers, and every detail is set out in your fixed written quote.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Bannockburn at a glance

Postcode districts
FK7
Population
about 7,040 (GeoNames)
Council area
Stirling Council
Building approval
Stirling Council building standards
Nearest main town
Stirling, about 2 miles
Guide price region
Scotland (−5% on West Midlands rates)

Why choose torch-on felt roofing in Bannockburn?

Torch-on felt is widely specified for blocks of flats and HMOs, in Bannockburn as elsewhere, because the system is well understood, widely repairable and governed by a British Standard code of practice. Three-layer builds with insulation are common on larger, multi-occupied roofs.

In a town like Bannockburn, flat roofs are commonly found on lock-up garage blocks on estates or terraced streets with flat-roofed rear kitchens and bathrooms. Scotland averages roughly 1,570 mm of rain a year, with the west far wetter than the east, so drainage, falls and wind uplift are part of every specification we write.

How much does a torch-on felt roof cost in Bannockburn?

For Bannockburn we use Scotland rates: £1,450–£2,500 is the guide for a typical 18 m² garage roof in torch-on felt, VAT included. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,450–£2,500
Extension (20 m²), felt, new deck + insulation£2,550–£4,450
Block of flats (150 m²), felt + insulation + scaffold£14,750–£25,850
Single garage (18 m²), EPDM rubber£1,500–£2,650
Extension (20 m²), EPDM, new deck + insulation£2,650–£4,650

Is torch-on roofing safe, and what is the difference between two- and three-layer systems?

Yes, torch-on is safe when hot works are properly controlled, because most roof fires linked to torching start at hidden timber or debris near edges and upstands, not on the open roof. Our teams follow a hot-works routine on every job:

  • check eaves, fascias, soffits and wall cavities for timber, nests and debris before lighting a torch;
  • use a cold-applied or self-adhesive membrane, rather than a flame, at edges, against combustible materials and in tight details;
  • keep fire extinguishers on the roof and the gas bottles secured and away from the work;
  • stop torching well before the team leaves, then carry out a fire watch so smouldering is spotted while people are still on site.

As for layers, a two-layer system (underlay plus cap sheet) is common on domestic roofs such as garages and extensions. A three-layer system adds an intermediate sheet, giving more thickness and redundancy, and is often specified on larger, commercial and multi-occupied roofs. The right choice depends on the size and use of the roof and the system's requirements, so we set it out in the quote.

Near a boundary, the external fire performance of the tested build-up, such as a BROOF(t4) classification, can also matter, and we check it where it applies.

What's included?

  • Mineral-finished cap sheet, upstands, outlets and edge trims
  • Hot-works checks and fire watch on every torch-on job
  • Vapour control layer and warm-roof insulation where needed
  • Deck inspection with replacement of damaged boards

Building standards in Scotland

In Scotland the building standards technical handbooks (Section 6 for energy) apply, and the council's building standards service decides whether a building warrant is needed. Like-for-like repairs to a roof covering can be exempt; alterations, structural work and new roofs usually need a warrant before work starts. The domestic roof benchmark is 0.12 W/m²K, applied as far as reasonably practicable on an existing roof. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Bannockburn: questions

Do you cover Bannockburn?

Yes. Bannockburn is part of our Stirling coverage, including postcode districts FK7. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building standards for a flat roof in Bannockburn?

Where the work needs approval it goes to Stirling Council building standards. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Bannockburn?

£1,450–£2,500 for a typical 18 m² garage roof in torch-on felt, at Scotland guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

How long does it take to lay a torch-on felt roof?

A garage roof typically takes one to two days and an insulated extension two to three. Larger roofs and blocks are phased over longer, with each area made weathertight before the team leaves.

Other flat roof work in Bannockburn

Torch-on felt roofing in Bannockburn: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price