Felling at a glance
- Postcode districts
- NE10
- Population
- about 34,355 (GeoNames)
- Council area
- Gateshead Council
- Building approval
- Gateshead Council building control, or a registered building control approver
- Nearest main town
- Newcastle upon Tyne, about 2 miles
- Guide price region
- North East (−7% on West Midlands rates)
Why choose torch-on felt roofing in Felling?
On larger roofs in Felling with poor falls, torch-on felt pairs well with tapered insulation, which builds the fall into the insulation boards. That deals with ponding properly while adding insulation, rather than patching the low spots and waiting for the next leak.
In a town like Felling, flat roofs are commonly found on shops with flat-roofed rear stores below flats or 1960s and 1970s link-detached houses with flat-roofed garages and porches. England averages roughly 870 mm of rain a year; the North East is drier than the west but cold and windy near the coast, so wind uplift and freeze-thaw are in the specification.
How much does a torch-on felt roof cost in Felling?
At North East guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,400–£2,450 including VAT. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), torch-on felt | £1,400–£2,450 |
| Extension (20 m²), felt, new deck + insulation | £2,500–£4,350 |
| Block of flats (150 m²), felt + insulation + scaffold | £14,450–£25,300 |
| Single garage (18 m²), EPDM rubber | £1,500–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,550 |
Is torch-on roofing safe, and what is the difference between two- and three-layer systems?
Yes, torch-on is safe when hot works are properly controlled, because most roof fires linked to torching start at hidden timber or debris near edges and upstands, not on the open roof. Our teams follow a hot-works routine on every job:
- check eaves, fascias, soffits and wall cavities for timber, nests and debris before lighting a torch;
- use a cold-applied or self-adhesive membrane, rather than a flame, at edges, against combustible materials and in tight details;
- keep fire extinguishers on the roof and the gas bottles secured and away from the work;
- stop torching well before the team leaves, then carry out a fire watch so smouldering is spotted while people are still on site.
As for layers, a two-layer system (underlay plus cap sheet) is common on domestic roofs such as garages and extensions. A three-layer system adds an intermediate sheet, giving more thickness and redundancy, and is often specified on larger, commercial and multi-occupied roofs. The right choice depends on the size and use of the roof and the system's requirements, so we set it out in the quote.
Near a boundary, the external fire performance of the tested build-up, such as a BROOF(t4) classification, can also matter, and we check it where it applies.
What's included?
- Mineral-finished cap sheet, upstands, outlets and edge trims
- Two- or three-layer reinforced bitumen membrane with staggered laps
- Deck inspection with replacement of damaged boards
- Vapour control layer and warm-roof insulation where needed
Building regulations in England
Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.
Which nearby areas do we also cover?
- Newcastle upon Tyne · 2 mi
- Wallsend · 3 mi
- Gosforth · 4 mi
- Jarrow · 4 mi
- Whickham · 4 mi
- Washington · 4 mi
Torch-on felt roofing in Felling: questions
Do you cover Felling?
Yes. Felling is part of our Tyne and Wear coverage, including postcode districts NE10. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Felling?
Where the work needs approval it goes to Gateshead Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a torch-on felt roof cost in Felling?
£1,400–£2,450 for a typical 18 m² garage roof in torch-on felt, at North East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Is torch-on suitable for a block of flats?
Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.
Can torch-on felt be laid in wet weather?
Not in rain or on a wet deck, because moisture trapped under the membrane causes blisters. Light cold weather is usually workable, but we will postpone rather than lay on a damp surface.