Brymbo at a glance
- Postcode districts
- LL11
- Population
- about 18,111 (GeoNames)
- Council area
- Wrexham County Borough Council
- Building approval
- Wrexham County Borough Council building control, or a registered building control approver
- Nearest main town
- Wrexham, about 3 miles
- Guide price region
- Wales (−8% on West Midlands rates)
Why choose torch-on felt roofing in Brymbo?
Torch-on felt is widely specified for blocks of flats and HMOs, in Brymbo as elsewhere, because the system is well understood, widely repairable and governed by a British Standard code of practice. Three-layer builds with insulation are common on larger, multi-occupied roofs.
Around Brymbo, flat roofs are common on shops with flat-roofed rear stores below flats and on low-rise post-war blocks of flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a torch-on felt roof cost in Brymbo?
For Brymbo we use Wales rates: £1,400–£2,400 is the guide for a typical 18 m² garage roof in torch-on felt, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), torch-on felt | £1,400–£2,400 |
| Extension (20 m²), felt, new deck + insulation | £2,500–£4,300 |
| Block of flats (150 m²), felt + insulation + scaffold | £14,300–£25,000 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
Should I choose torch-on felt or a different flat roof system?
Choose torch-on felt when you want a proven, layered system at a sensible price, particularly on larger roofs, blocks of flats and commercial buildings where several layers give useful redundancy. It is a weaker choice where hot works are hard to manage safely.
For: generally lower cost per square metre; two or three layers, so a single defect in one layer need not cause a leak; tough mineral finish; long track record and a British Standard code of practice; repairs can be made with compatible materials.
Against: needs a naked flame unless a cold-applied or self-adhesive alternative is used; shorter typical life than EPDM or GRP; the finish is functional rather than decorative; more laps to detail than a single sheet.
On small domestic roofs near timber, EPDM avoids the torch entirely. GRP gives a harder, neater surface. For an overlay, a liquid-applied system is often simpler. Large commercial roofs may suit single-ply, and older buildings may suit mastic asphalt. See our comparison guide.
What's included?
- Two- or three-layer reinforced bitumen membrane with staggered laps
- Hot-works checks and fire watch on every torch-on job
- Deck inspection with replacement of damaged boards
- Strip-off of the existing roof covering and removal of waste
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Torch-on felt roofing in Brymbo: questions
Do you cover Brymbo?
Yes. Brymbo is part of our Wrexham coverage, including postcode districts LL11. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Brymbo?
Where the work needs approval it goes to Wrexham County Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a torch-on felt roof cost in Brymbo?
£1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Why does my felt roof have blisters?
Blisters usually form when moisture or air trapped beneath the felt expands in the sun. A few small, intact blisters may be monitored, but widespread or split blisters point to a repair or replacement.
Can torch-on felt go over an existing felt roof?
Sometimes, if the old roof is dry, well bonded and the deck is sound. Often stripping is better, because overlaying can trap moisture and hide rot; our guide to overlay or strip explains how we decide.