Holyhead at a glance
- Postcode districts
- LL65
- Population
- about 11,431 (GeoNames)
- Council area
- Isle of Anglesey County Council
- Building approval
- Isle of Anglesey County Council building control, or a registered building control approver
- Guide price region
- Wales (−8% on West Midlands rates)
Why upgrade to a warm roof in Holyhead?
Kitchen extensions in Holyhead, as elsewhere, produce a lot of moisture from cooking. Under a cold flat roof, that moisture can condense on the deck. A warm roof keeps the deck warm and puts a vapour control layer in the way, which lowers the risk considerably.
Around Holyhead, flat roofs are common on shops with flat-roofed rear stores below flats and on bungalows with flat-roofed side extensions and dormers. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a warm roof upgrade cost in Holyhead?
At Wales guide rates, a 20 m² extension roof in EPDM with a new deck and insulation comes to £2,600–£4,500 including VAT. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
| Extension (20 m²), EPDM with sedum green roof | £4,050–£7,450 |
Do I have to insulate my flat roof when I replace it?
Usually, yes, if the roof is over a heated room and you are replacing more than half of its covering. In England, Wales and Northern Ireland, that counts as renovating a thermal element, so the roof should be upgraded to the renovation standard where that is technically, functionally and economically feasible.
The rules don't usually apply to patch repairs, or to an unheated, detached garage. The target U-value depends on where you live:
| Nation | Roof renovation target |
|---|---|
| England | 0.16 W/m²K (homes), 0.18 (non-domestic) |
| Wales | 0.16 W/m²K |
| Scotland | Section 6 framework, with a domestic benchmark of 0.12 W/m²K pursued as far as reasonably practicable |
| Northern Ireland | 0.18 W/m²K |
A new extension roof has a tighter target than a renovation: 0.15 in England and 0.13 in Wales. The economic test in England's guidance is a simple payback within 15 years. We handle building control or building standards where it is needed. The building regulations page sets out the approval routes in each nation.
What's included?
- Upstands, trims and kerbs reset to the new roof level
- Survey of the deck, joists and existing insulation
- Vapour control layer on the warm side of the insulation
- Building control or building standards handled where needed
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Warm roof insulation upgrades in Holyhead: questions
Do you cover Holyhead?
Yes. Holyhead is part of our Isle of Anglesey coverage, including postcode districts LL65. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Holyhead?
Where the work needs approval it goes to Isle of Anglesey County Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a warm roof upgrade cost in Holyhead?
£2,600–£4,500 for a 20 m² extension roof in EPDM with a new deck and insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Is there VAT relief on flat roof insulation?
Don't count on it. Insulation fitted as part of a roof replacement is usually treated as part of a single standard-rated job. Check your own case with HMRC guidance or an adviser.
How thick does flat roof insulation need to be?
It depends on the insulation product and the U-value target. With common PIR boards, meeting a renovation target usually means well over 100 mm. Thinner, higher-performance boards are available where height is tight.