Flat RoofingContractors

Roofs we replace and build

Dormer roofs across Somerset

Dormer roofs across Somerset are usually small but awkward: high up, over a bedroom and tied into a tiled roof. We plan the scaffold, insulation thickness and back-edge detail at survey, then lay GRP or EPDM with new trims. Building control or building standards are handled where the work needs them.

Rear box dormer with a grey GRP flat roof and anthracite cladding on a Victorian terraceComputer-generated example image
Guide price
£1,450–£2,750
Survey
Free for new and replacement roofs
Quote
Fixed, in writing
Coverage
England, Wales, Scotland, NI

Somerset at a glance

Largest towns
Bath, Weston-super-Mare, Taunton, Yeovil
Postcode areas
BA, BS, TA
Building control
Bath & North East Somerset Council, North Somerset Council and Somerset Council
Neighbouring areas
Bristol · Wiltshire · Gloucestershire · Dorset
Guide price region
South West (+3% on West Midlands rates)

How much does a new dormer roof cost in Somerset?

Guide prices including VAT at South West rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Dormer (8 m²), GRP, scaffold£1,450–£2,750
Single garage (18 m²), EPDM rubber£1,650–£2,900
Extension (20 m²), GRP, new deck + insulation£3,100–£5,550

Which flat roofs are common in Somerset?

Flat roofs in Somerset sit on terraced streets with flat-roofed rear kitchens and bathrooms, shops with flat-roofed rear stores below flats and lock-up garage blocks on estates. The South West averages roughly 1,260 mm of rain a year and many roofs face wind off the Atlantic, so we specify fixings and edge details for wind uplift as well as drainage. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in England

Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Somerset the application goes to Bath & North East Somerset Council, North Somerset Council and Somerset Council. More on the rules.

Why is scaffold and tile detailing so important on a dormer?

Because a dormer roof is high, small and surrounded by a pitched tiled roof, most failures happen at the edges rather than in the middle. Safe access is what allows those edges to be done properly.

Ladders alone do not give a safe working platform at that height, and every roof is treated as fragile until a competent person confirms otherwise. Scaffold with edge protection lets the team work along the front and sides of the dormer, and reach the junction with the main roof.

The back of the dormer is where most leaks start. The new membrane has to turn up under the tiles or slates, with a flashing that sheds water over it. Where the old detail used lead, we reinstate or replace it. Small roofs also leave little room for error at the drip edge: the front trim must throw water clear of the window frame and fascia, and any gutter has to be big enough for the area it drains. Dormer cheeks with tile hanging or cladding are checked for gaps that let water behind.

If you are also planning insulation upgrades or work on the main roof, tell us at survey so the scaffold can be shared.

Do I need building regulations approval for a dormer roof?

Usually, yes, if you are replacing most of the roof. A dormer roof sits over a heated room, so it counts as a thermal element, and renovating more than half of it normally means upgrading the insulation where feasible.

In England the renovation target is 0.16 W/m²K for homes, approved through building control or a competent person scheme. Wales usually needs approval for most re-roofing work. Scotland works through the council's building standards and, where required, a building warrant. Northern Ireland asks you to contact district council building control before starting.

Insulating above the deck raises the roof slightly. On a dormer, that extra height has to fit under the main roof tiles at the back edge, so the build-up is planned at survey. Re-covering a dormer that looks the same afterwards does not usually need planning permission, but a listed building or conservation area may bring extra controls. More on our building regulations page.

Which towns in Somerset do we cover?

Dormer roofs in Somerset: questions

Which towns in Somerset do you cover?

All of Somerset. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a new dormer roof cost in Somerset?

£1,450–£2,750 for an 8 m² GRP dormer roof including scaffold, at South West guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which council handles building control for a flat roof in Somerset?

It depends on where the roof is: in Somerset that's Bath & North East Somerset Council, North Somerset Council and Somerset Council. Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. We confirm which applies at the survey.

Can a dormer roof be replaced without scaffold?

Rarely. A tower or full scaffold is usually needed to give a safe working platform and edge protection at that height.

Is a dormer roof cheaper than a garage roof?

Not by as much as the size suggests. Scaffold and the extra detailing at height mean a small dormer roof often costs about the same as a single garage roof.

Will insulating my dormer roof make it higher?

Yes, by the insulation thickness. We plan the build-up so the new roof still sits correctly under the main roof tiles at the back edge.

Everything about dormer roofs → · All flat roofing in Somerset →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price