- Price per m²
- £57–£101
- Typical life
- 25–50 years
- Manufacturer guarantees
- 20-year material warranties are common
- Typical garage roof
- £1,400–£2,450
County Londonderry at a glance
- Largest towns
- Derry/Londonderry, Coleraine, Limavady, Magherafelt
- Postcode areas
- BT
- Building control
- Derry City and Strabane District Council, Causeway Coast and Glens Borough Council and Mid Ulster District Council
- Neighbouring areas
- County Tyrone · County Antrim · County Armagh · Belfast
- Guide price region
- Northern Ireland (−12% on West Midlands rates)
How much does an EPDM rubber roof cost in County Londonderry?
Guide prices including VAT at Northern Ireland rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), EPDM rubber | £1,400–£2,450 |
| Extension (20 m²), EPDM, new deck + insulation | £2,450–£4,300 |
| Porch or bay (4 m²), EPDM | £650–£1,100 |
Which flat roofs are common in County Londonderry?
Flat roofs in County Londonderry sit on bungalows with flat-roofed side extensions and dormers, newer estates where the first extension roofs are now being replaced and shops with flat-roofed rear stores below flats. Northern Ireland averages roughly 1,150 mm of rain a year, spread over many wet days, so a roof that sheds water quickly to clear outlets lasts far longer than one that holds puddles. Approximate 1991–2020 regional averages based on Met Office data.
Building control in Northern Ireland
In Northern Ireland, renovating or replacing a roof over a heated room usually means meeting Technical Booklet F1, and building control should be contacted before work starts. Technical Booklet F1 sets roof insulation at 0.18 W/m²K when a roof over a heated room is renovated or newly built, where feasible. In County Londonderry the application goes to Derry City and Strabane District Council, Causeway Coast and Glens Borough Council and Mid Ulster District Council. More on the rules.
Do I need building regulations approval to replace a roof with EPDM?
Often, yes. In England, Wales and Northern Ireland, re-covering more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof should be insulated towards the renovation standard where that is feasible; in Scotland, the council's building standards service decides whether a building warrant is needed.
An unheated detached garage normally falls outside these rules, and a patch repair is treated differently from a full re-cover.
In practice that means a warm roof: insulation above the deck, a vapour control layer beneath it and the EPDM on top. The extra thickness lifts the finished roof, so at survey we check door thresholds, window cills, wall flashings and upstand heights, aiming for an upstand of about 150 mm above the finished surface. Where approval is needed, we deal with building control or building standards for you. The building regulations page and our warm vs cold roof guide go into more detail.
When is EPDM the right choice, and when is another system better?
EPDM is a strong choice for simple domestic roofs that people do not walk on, such as garages, single-storey extensions, porches and dormers. It is less suited to roofs with regular foot traffic or many pipes and vents.
Where it does well: few or no joins on small roofs, flexible in cold weather, tolerant of minor building movement, and laid without a flame.
Where it falls short: the finish is plain dark rubber, it can be punctured by dropped tools or sharp debris, and it is not designed as a walking surface without added protection. Roofs with many penetrations take a lot of careful detailing.
If you want a hard, walkable finish or a complex shape, GRP fibreglass often suits better. On a tight budget, or a larger roof where a layered system is preferred, torch-on felt is worth pricing. Liquid-applied roofing handles awkward details and overlays, single-ply membranes are built for larger commercial roofs, and mastic asphalt belongs on older and heritage buildings. Our EPDM vs GRP vs felt guide sets them side by side.
Which towns in County Londonderry do we cover?
EPDM rubber roofing in County Londonderry: questions
Which towns in County Londonderry do you cover?
All of County Londonderry. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does an EPDM rubber roof cost in County Londonderry?
£1,400–£2,450 for a typical 18 m² garage roof in EPDM, at Northern Ireland guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which postcode areas do you cover in County Londonderry?
All of County Londonderry, including the BT postcode areas. Send your full postcode and we'll confirm.
Can EPDM be laid over an old felt roof?
Sometimes, but we usually recommend stripping old felt first. Overlaying hides any rot or wet insulation underneath, and over a heated room a full replacement is often when insulation has to be added anyway.
Can a punctured EPDM roof be repaired?
Usually, yes. The area is cleaned and primed, then an EPDM patch or cover tape is bonded over the damage. If water has reached the deck, a survey first is sensible.
Can you walk on an EPDM roof?
Occasionally, for maintenance, yes, but EPDM is not designed as a regular walking surface. Where you need a route to plant or windows, walkway pads can be bonded on, or GRP may be a better fit.
Everything about EPDM rubber roofing → · All flat roofing in County Londonderry →